You're a pro at using our tool! Skillful demo of the floating spacer aligner and bearing press. Another method to remove a bearing from a tight wheel is to rotate the bearing extractor around the bearing center.
Where sell that unbreakable screen? Haha Nice video 👍🏼 i start to use reds big ball bearing there are so smooth but can you say that rollerblade ilq9 bearings are better than reds bearings?
Hahahahah hmmm great question! I had the bones BIG Ball bearings too. Yes my personal opinion is the ILQ 9 is faster. I haven't personally tested that but it sure feels like they are. So far I like the ilq-9 Almost as much as the bones Swiss. But that is my personal opinion.
Where can I order new ufs frame bolts, I have the same skates and I over screwed it and now it’s stuck so once it comes off I will have to replace the bolts but can’t find them anywhere, if you have a link I’d super appreciate you, I have new frames and ready want to try them 😅, and Ty much appreciated your video, very helpful 👊🏻👍🏻
@@jadrollervlog I made the order, then realized I only ordered one of each bolt instead of two but don’t have enough for shipping again so gotta wait till payday lol I’m a idiot but very thankful 🙏🏻 for you, I searched everywhere for those with no luck so you were a blessing plus I ordered a kit so I should be good 👍🏻, God Bless and have a great week 🫱🏻🫲🏼😁
I have two questions: 1- Do you recommend using an ultrasonic cleaner? 2- is it safe to use acetone on the white-bearing ball holder (the white plastic that holds the balls)?