Charlton and Jenrick Purevision HD Stove Training Video 

Thanks, we appreciate that 👍 Glad you found it useful.

We're glad you like it! The PVR is one of our personal favourites as well 🔥

@@charltonandjenrick hi do you have a video on the correct operation of the FX 8 .I'm following your manual and struggle to get a good heat output. The wood I'm using is at 10 to 12 % hard wood. This video has given me a different approach..so I give it a go .

@@paulsimpson2232 Hi Paul, The way the logs/firelighters are arranged will work for the FX8. Open the air control fully (top slider) and the bottom air control fully to start and leave the door ajar. Once the fire has started, close the door and control the heat with the bottom air control. Always leave the top slider open, as closing this might cause your glass to go black.

No problem! Glad you found it useful

Hi Iwan, this is concerning to hear. I would reccomend you contact our our service department who can help you identify the issues you are having. Their number is 01952 217 501. Thanks

Hi Robert, When in automatic mode, the baffle opens automatically when you open the door, then closes when you close the door reducing the amount of smoke coming into the room and heat loss. Please see this video for a detailed explanation of how the Active Baffle works- ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-7mmUPa9QWQg.html Thanks

@@charltonandjenrick Hello i have just put my fire on for the first time and my air control is opposite to that shown in the video, my air control opens on the right and to close it down towards the left. Is that a problem ? Also is there a temperature to reach to burn the soot off the glass ? or will i just have to clean it ? I think it sooted up because i closed the air control when lighting the fire because air control is the other way around. I have the PVB5.

@@ratclifferob Hi Robert, If you open the airwash the glass should clear by itself in time although you could clean it as well. The air control goes both ways, depending on whether you are burning wood or coal, and this should be written on the metal control.

@@charltonandjenrick Hello i have just figured out that i had to lift the air control over the marker to burn wood because it was set for coal. The glass is clearing slowly. Could you tell me what should be the maximum heat as all thermostats have different heat levels ? Thanks for the swift reply.

@@ratclifferob Hi Rob, There is no maximum heat a stove should run at, there are too many factors it depends on. What we would say is there is normally a safe zone indicated on any flue thermometer so as a rough guide keep it in that range. Thanks

Hi Don, Sorry for the confusion, Fireline is part of the Charlton and Jenrick group. Here is a link to the Fireline Stoves section- www.charltonandjenrick.co.uk/products/stoves-2/fireline-stoves/. Thanks

Thanks for your question. As far as we know there isn’t anything available on the market that will do this as a retrofit for any current stoves. Unfortunately we don’t have a boiler stove to offer at the moment.

A few minutes after the logs catch fire, when they are burning well.

thanks@@charltonandjenrick

The active baffle opens up allowing the smoke to go up the chimney instead of the room when refuelling. it also opens up when starting to enable the stove to be started easier and quicker.

They are made in a Chinese factory that we own and operate, after being designed and tested here. This gives us the best combination of quality and value.