How to set up and use a affordable Nano VNA meter to check your antennas SWR range and look for faults. Build your own antennas and check and adjust their peak SWR easy with this cheap meter. Great for CB radio. Buy here. ban.ggood.vip/14bQC
NanoVNA-PCB 10KHz-1.5GHz MF HF VHF UHF Digital Vector Network Antenna Analyzer Support 32G SD Card
Specification:
- PCB: 54mm x 85.5mm x 11mm without the size of connectors, switches
- Measurement Frequency: 10KHz -1.5GHz
- RF Output: -13dbm maximum -9dbm
- Frequency Accuracy: 0.5ppm
- Measurement Range: 70dB 50kHz-300MHz, 50dB 300M-600MHz, 40dB (600M-900MHz) enable extended firmware)
- Port SWR: 1.1
- Display: 2.8 inch TFT (320x240)
- USB Interface: USB Type-C; Communications Mode: CDC (Serial)
- Power Supply: USB 5V 120mA, built-in 650mAh electricity, maximum charging current 0.8A
- Number of Calibration Points: 101 (Fixed)
- Number of Scanning Points: 101 (Fixed)
- Display Tracking: 4, Marking: 4, Save Setting: 5
- Measuring S parameters, voltage standing wave ratio, phase, delay, Smith chart and the like
Package included:
1 x NanoVNA Host (2.8-inch touch screen and 650mAh battery is included)
2 x 20cm SMA Male to Male RG174 RF Cable
1 x USB Type-C Data Cable
1 x Type-c to Type-c Line
1 x Stylus Pen
1 x Touch Paddle
2 x SMA Female to Female Connector
1 x SMA Simple Calibration Kit SHORT
1 x SMA Simple Calibration kit OPEN
1 x SMA Simple Calibration kit LOAD
2 x SMA Female to Female Connector
7 июн 2024
