I'M NOT A MECHANIC OR A PROFESSIONAL SO IF YOU ARE IN DOUBT SEEK PROFESSIONAL ADVICE AND GUIDANCE. THIS VIDEO IS FOR ILLUSTRATIVE PURPOSES ONLY.
OK that being said go check out or have your RYKER checked out to see if this part isn't seated right. So I had read a story on FB about someone who had this part apparently fail or fall out and it caused his wheels to violently wobble( paraphrasing the original story). I went out and checked mine and found that the plastic wasn't seated quite right. So I ordered new parts and replaced the originals. It wasn't hard or expensive and I can say that on subsequent test rides my steering has not been negatively effected. I'm not an expert but I don't think you will notice anything until it possibly fails. I don't think its would hurt to look at it and make a decision. I also don't know how widespread this is as I haven't seen any other posts on it. There are only 3 parts if you reuse the original bolts and it cost me less than 20$ so I think it was worth the money. Effort wise it wasn't difficult but due to when I did it ,it was uncomfortable. I'll list the part numbers I used below but double check for your year and model.
RH LOWER COLUMN ATTACHMENT
709401969
HALF BUSHING(2x)
709402919
Ride safe and I hope this doesn't effect you. See ya in the next one.
MUSIC USED UNDER LICENSE FROM ARTLIST
#canamonroad #canamspyder #canamryker #Ryker #Spyder #ridelikenother #WeCanAllRide #Can Am
4 окт 2024
