Next Time prime the pump first by turning ur key to start position two to four time without starting d engine than check for leaks than start ur engine. Stay safe 😎😎😎
Thanks for the procedure. The problem is (in your case, i guess you are lucky) when the gas lines are so rusted that you cannot remove the filter on the side with one inlet. I have the same tool and it doesn't push the tabs to release the filter. It was so rusted that the 10mm bolt that holds the bracket snapped when removing. I sprayed PB blaster, compressed air and pushed so fucking hard on it without any release. They should of put those plastic clips on all three fittings. FYI for all trying this with rust...
My car is pretty rusty and the bolt on the bracket broke off In half.. do I need to have the bracket on there or can I just superglue the bracket on there (I don’t plan to have the car long enough to need to change it again)
Do you know the mesure of the removal toll? I have to connect the old back because i bought a multitool and they were too big. I need to buy the right one.