Chrysler 200 Throttle Body Replacement 

You were so much help. I’m a single mom and I always go to RU-vid to learn how to fix my car. Your video was the best I’ve seen yet.

Next time (for the video)-- just take a few minutes and cut open the old one with a cutting wheel, and you will typically find that the little plastic gears are broken on the inside. There's an electric motor with a small gear (sometimes it's a worm gear)-- and then there's a long sweeping gear that connects to the butterfly shaft-- and that will typically break off a tooth or crack in a few places, because of it having to overcome the sticky gunk in the throttle body. The cheaper brands tend to break for no apparent reason, just from heat cycles on the cheap plastic. For the OEM's, it usually takes a really gunked up butterfly getting stuck, or even getting frozen or iced over, etc.. Cutting them open would make for great 'bonus content. You can usually learn a lot just by taking a peak inside; there's nearly always something very obvious inside.

Thank you sir! I was worried about paying over $500 when I can just do it myself! SUBCRIBE!

Super easy explanation. Thank you. Going to replace mine myself.

This video helped me for my car so much. 😊

Love it man.. thank you

I have 2015 with same light on do I need to program it or just reset the gas pedal reset

I'm going to get me some drills and work on things my self. Ty and I may replace my throttle

THANK YOU SIR!!!

Good job buddy you really are a good mechanic 🧰

Great video

Good video 👍 👍

Need help because somebody put different connector for throttle body and buy but the connector is same like you show video but I'm not how conect wires

Hello! I have a 2013 Chrysler 200 that currently has the throttle light on the dash. I just finished replacing the ETB and ran it for any codes but it still won’t start. I also checked for a weak battery and no sign of anything. Any help or suggestions are appreciated!

Enay has some inexpensive 👍

What if I don't do a relearn

Oh please help me!!! I am replacing my throttle body tomorrow 2/5/23…. I got the new part in the mail. (I didn’t go to local store) when I tip the ETB with the gears down. There’s a noise like a pin dropping against the plate. Is this normal with the throttle body? Also, is there a manual relearn procedure for us who don’t have a scanner like yours? I looked into my obd2 and it doesn’t offer the relearn for ETB.. please help. I’m also thinking, if I disconnect the negative cable, does that bypass the relearn procedures? Thanks in advance!

Do you have video taking it off?