Cladding Drip Corner Flashing On Site 

Sorry don’t understand what your saying here, can you tell me a time stamp in the video where I can see what you mean please

@@cw7700 like, the two rectangles that he folds down, he goes and cuts them flush where the back is. He should leave one of the sides there and fold it around the corner so he has a nailing spot on both sides to keep the two sides tight against the wall. And he's able to some good caulking from the top of the flashing, down to where a pinhole would be, and under the one side of the flashing that's sitting. Caulking isn't exposed to uv rays so it'll definitely last 20+ years if it's a good quality caulking Don't get me wrong he did a great job but it's just the tiny details and reassurance with caulking that make it stand out compared to the thousands of other people who do it like that

@@cw7700 2:27 + flashing and the underlaymet need to be at last 15*

​@@cw7700 He's saying that you should have left an ear on the topmost vertical portion of your corner cut on the left side to fold over at a 90° underneath the right side when folded over providing an overlap instead of an open cut with nothing bridging the gap in between the two intersecting sides.

Water won’t get past a kingspan panel that sits on top of this

Thank you mate, midwest snips

Tracer pencils mate, toolstation/screw fix/Amazon

No need, the guys a tank

Really?

I think you need to look at zinc roofing mate, check out RU-vid channel architectural sheet metal 101

a dog ear … common detail in hard metal roofing

Upstand/stop end. Just leave extra 100mm on that plain of the flashing, score the underside, to allow it to bend, bend it, then cut to the required height. You leave a bit to go around the vertical leg too. To seal it all off. But my explanation would probably confuse you.

I think you need to measure the depth of the drip mate and come across that measurement from the centre line.

See the video at 40 seconds mate

Top man

There will be silicone under the mitre I was only showing the cuts

@@cw7700 in poland if you use silicone you are not roofer. You must make seam on corner

@@oldsharke2840 well this video is not in Poland, and can you send a link that shows in the rules and regulations that if you use sealant in Poland your not a roofer ? I'll wait for the link you provide, cheers

@@garethhancock8525non compliant even here in Australia.

@@NightlifeReALIty it is compliant in the uk and until I get called back to see a water leak I’ll continue to do it like this, been ok for the last 20 years