No video :(

Lets Make An Outside Corner In Some Custom Brick Ledge Flashing | At The 509

Подписаться 2,7 тыс.

Просмотров 22 тыс.

50% 1

In this video I am going to show you how I cut a custom outside corner, or miter, in some custom black aluminum brick ledge flashing.
#barkriverknives #fixedblade #cubedc #3v #magnacut #bladesteel #strop #customsheetmetal #seamlessgutter #downspouts #gutter #sheetmetal #shrinkerstretcher #atthe509 #flashing #circletopwindowflashing #sheetmetalhem #spacer #circletopdoorflashing #viral #viralvideo #project #customerorder #sheetmetalshear #scribe #efficiency #jadeg10 #blackcanvasmicarta

Опубликовано:

6 апр 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 9

@dn8533 2 дня назад

Thanks

@dn8533 2 дня назад

Can you do a video on how to do inside corner as well?

@paulnovak833 Год назад

Perfect video. Thanks!

@Josh-ww5kz 9 месяцев назад

If you want to go a step further, leave the drip edge piece that you cut off, on there and have the next side of the corner piece cut at a 45, then bend that little tab around the side that has the 45° cut and it it make the corners look even neater.

@artetaDagoat 5 месяцев назад

Essentially, it's one piece?

@Josh-ww5kz 5 месяцев назад

@@artetaDagoatthe way shown in the video leaves little triangles on the corners, if you leave a tab on it it will close it up and make it seem like it one piece going all around. only a look you can achieve if you leave a tab on the drip portion and bend it around. its only needed when you have that little kick on flashings