CLEANING A RUSTY TABLE 

This is one of the first wwga videos I ever watched. Smart to re-release it.

Your timing for re-releaseing this is great. Covid has resulted in a 2 income family being reduced to a single income. So instead of settling for 9 to 5 we're investing in our plans. The resources are stretched to look for secondhand tools and equipment. Thank you.

Exactly what I was looking for. I was gifted a old cast iron table saw and have been restoring

I lived in Florida and the weather there with the salt in the air is ruff on finish cast iron. I bought some acid from woodcraft and another product that seals the top. I also keep a silver thin bubble wrap on top with a slice in it for the blade. So far it's stays clean

So funny, I used this video to rehab a 1970s craftsman tablesaw top years ago. Good to revisit as I refinish metal bbq shelf this weekend. Thanks uncle George and team.

Too much work, I use an orbital sander with WD40 going up and down in the same direction across the top, then finish off with a good carnauba paste wax, and a buffing pad on the orbital. The woods slides nicely, and it lasts for months. Thank you so very much for your videos, but I do wish they were higher than 240p in quality, it looks so blurry. Remember if you upload higher quality it will default the best quality for faster playing on most devices automatically.

Yes GR8 timing on the RE-release. I just bought an older jointer in GR8 condition other than a little surface rust - a lot less than in your video. Thanks

Good advice. Pity about the video quality. I would always use a fine grit (400 or better) sandpaper on a block to ensure it stays as flat as possible. I like that the video shows multiple passes, since that's often needed and much better than using aggressive approaches like a wire brush.

Good video, like that you took the table off the machine to clean it.

I used to work on paper paper cutters, we kept rust at bay with silicone spray as you can’t oil the bed as it gets on the paper, you should try it

Just use Evaporust to remove the rust. No rubbing. Then get it copper plated then Nickel electroplated.

Great Video

What table top sealer did you use?

What exactly is degreaser? Is that mineral spirits or isopropyl alcohol? Or either one is fine?

they make a scotch brite wheel for your angle grinder these days. Will make light work of this

What is the table top sealer product?

Can I use a wire wheel on grinder?

How do you clean a rusty trombone?

You keep calling it a TABLE SAW, looks like a BAND SAW top to me. Otherwise, great video.

ended up with black streaks on table

Filming a video Summer 2020 - in 240p. 😵‍💫

This is a how not to video.

this is why i unsubuscribed from your content, there is never anything new, in fact most of it is a decade old. you've milked it enough already..