No video :(

Cleaning Car Battery Corrosion and Applying Preventative

Подписаться 38 тыс.

Просмотров 55 тыс.

50% 1

NOCO NCP2 CB104 4 Oz Oil-Based Brush-On Battery Corrosion Preventative, Corrosion Inhibitor, And Battery Terminal Grease (Amazon Affiliate)
US: amzn.to/3gkYaIO
CA: amzn.to/3oCTTqc
NOCO NCP2 B603 Oil-Based Battery Terminal Protectors, Anti-Corrosion Washers, And Battery Corrosion Pads (Pack of 50) (Amazon Affiliate)
US: amzn.to/3ahDqOo
UK: amzn.to/41HCqLE
Battery Terminal Cleaning Brush (Amazon Affiliate)
US: amzn.to/2ssvVBF
CRC Industries Battery Cleaner - 12 OZ. AEROSOL (Amazon Affiliate)
US: amzn.to/3UVvQhK
CRC 05103 QD Electronic Cleaner (Amazon Affiliate)
US: amzn.to/2QsvBMv
Please follow me!
/ rickmakes
/ rickmakes
Visit my Amazon Storefront!
www.amazon.com...
www.amazon.co....
www.amazon.ca/...
Support my channel!
www.rickmakes....
#autorepair #battery

Опубликовано:

27 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 39

@BixbyConsequence 2 года назад

It's also a good practice to clean the entire top of the battery case. Acid mist from off-gassing can combine with the dust and create a conductive path all the way across the top to the opposite terminal and cause a constant low-level drain. Use a damp paper towel followed by a dry one and you're good to go.

@neogeo8267 3 года назад

Warm water + Baking Soda. Job done.

@Rickmakes 3 года назад

Baking soda works great.

@mattwaters6987 2 месяца назад

Yep. Worked amazingly well for me when I cleaned the terminals last week. 👍

@piedadstoffel5955 2 года назад

I highly recommend Ncp2 battery corrosion preventative spray and distilled water

@Rickmakes 2 года назад

I used to use a Permatex anti-corrosion spray but I like the coverage better with this brush on protection. It is easier to get in the nooks and crannies. I still do like spray on occasion. It is nice for hold down hardware. I'll have to try the NCP2 spray as I have been happy with their other products. Thanks for the recommendation!

@melvy67 6 месяцев назад

Very well explained on how to clean battery terminals thanks 👍🏾👍🏾

@guitar14 3 года назад

I’ve always used the red/green felt terminal rings. I never knew they made that type. Thanks.

@Rickmakes 3 года назад

When I worked in a shop, I think ours were a deep red. They were very "wet". They worked great. We used them on every install.

@mshahzzad Год назад

Very good procedure and guided car Cleaning Battery Good Job

@mrcarrepairman 3 года назад

acid free vaseline is what i use on battery terminal after i clean oxide or corrosion.

@curiosity2314 11 месяцев назад

Good information. Noco does make some very good products.

@syedjavedahmad9719 Год назад

Thanks for the tutorial. 👍👍.

@mmma4096 7 месяцев назад

hi, that cable between positive and negative terminals, what cable is that and where they are connect? I have in my car and is losing, no connect anything.

@Rickmakes 7 месяцев назад

That is a wire I installed to connect my battery tender. I use it to keep my battery charged when I don't drive it for a long time.

@mmma4096 6 месяцев назад

@@Rickmakes Thanks for let me know. I just removed mine.

@N9olan 2 года назад

Hit the highway and drive for 25miles going and coming.

@stevestudley5685 Год назад

Nice job. Thank you.

@BravesFan30281 11 месяцев назад

How often should the battery corrosion prevention stuff be applied? I bought the NCP2 spray to prevent corussion. But the instructions do not say how often it should be applied to prevent corussion.

@Rickmakes 11 месяцев назад

I typically apply corrosion protection when I am installing the battery. It generally lasts the life of the battery so long as you don't wash or wipe it off. It usually works very well but when I do see corrosion after applying the protectant, it is typically on a spot on the terminal that was missed. I like the brush applicator since it allows me to get into nooks and crannies.

@cristian7v 10 месяцев назад

So if I wanna jump start my battery would I have to clean the red stuff sprayer or just started in like that

@mostlymoparih5682 2 года назад

Why didn't you clean the top of the battery?

@Rickmakes 2 года назад

I could have but it isn't vital to the performance of the battery. I could wipe it with a wet cloth. You want to be careful about using chemicals to clean it as you could accidentally remove labels and date codes (used for battery warranty). Some batteries also have recessed battery caps that you don't want to flood with water.

@JesusGonzalez-fz5ng 10 месяцев назад

Bro if I was a battery tech and saw that goop on there I’d make u wipe that crap off. Pads are the best and just stay on your maintenance and clean ur damn terminals every couple months

@Rickmakes 10 месяцев назад

If you prefer cleaning terminals every few months, go for it. I prefer using the protectant and not messing with them. In my experience as a battery tech, I can tell you most people ignore their corrosion until it is too late. I replaced a lot of terminals due to this.

@raphajay Год назад

is there a certain amount of time I should wait after putting the anti corrosion stuff on the battery to start my car

@5150roc 2 года назад

Disconnecting your batter will effect your brain and it will have to reset and may poss issues after. Using HOT water without disconnecting works great.

@Rickmakes 2 года назад

Yes, it can upset the brain. Hot water can work but it depends on the extent of the corrosion. It also can be worth it to disconnect if the terminals weren't cleaned properly when the battery was installed. I have seen countless problems that stemmed from dirty or loose connections.

@FranzCritchlow 3 года назад

You voluntarily open the hood of your vehicle :-o

@JamesZ-py1xl 8 месяцев назад

Whats the importance of the terminal pads?

@Rickmakes 8 месяцев назад

To me it is a belt and suspenders approach. Often times the top of a terminal might have a corrosion preventative but the bottom of the terminal is unprotected because it is hard to apply preventative there. The rings give good protection under the terminal while the brush on coating protects the top.

@JamesZ-py1xl 8 месяцев назад

@Rickmakes oh OK I just cleaned my terminals and noticed I didn't have any so I was just asking because I don't have them.

@ivancho5854 7 месяцев назад

The pads are usually impregnated with an agent to neutralise the acidic vapour which escapes from between the plastic body of the battery and the post.

@kingspade897 3 года назад

Any feedback review about it ?

@Rickmakes 3 года назад

I just checked on it and there wasn't a hint of corrosion. When I worked in a shop, the similar anti-corrosion rings we used worked great.

@MrHipp00 Год назад

is this the same as dialectic grease?

@Rickmakes Год назад

Dielectric grease is silicone based. This is oil based. It doesn't seem to be the same stuff. Dielectric grease could work but I would think it might be hard to clean off if it got on the conducting part of the terminals.

@etow8034 Год назад

Dielectric grease is better and is the stuff you are suppose to use instead of petrolatum and is much versatile for spark plug boots and cable connectors. Dielectric grease will not run when hot, waterproof nor will it attack wiring jacket material like a petroleum based product. I use the NOCO NCP2 anti-corrosion terminal pads, but use dielectric grease on the metal terminal posts. Just because this product was made in 1914 doesn't mean it is the best product for today's use !

@tabby4990 Год назад

Your making it more complicated then it has to be. Just boil hot water and pour a cup hot water over the cable no need to disconnect. I put a bit of baking soda a too. It fizzles like soda and dissolves immediately!