Тёмный

Cleaning NASTY LS Engine To Look Like New! 

Red Goat Garage
Подписаться 970
Просмотров 17 тыс.
50% 1

Опубликовано:

 

29 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 11   
@2bitProjects
@2bitProjects Год назад
I am just impressed how you rolled the engine stand on the grass!
@redgoatgarage
@redgoatgarage Год назад
haha well I wouldn't say "rolled" really. It more of a life and scoot type deal.
@kilofoxtrot5476
@kilofoxtrot5476 Год назад
How many miles are on that LM7? Mine has a little over 200,000 and was thinking about doing this to mine along with putting new gaskets on.
@redgoatgarage
@redgoatgarage Год назад
I really don't know - I want to say the Tahoe said around 200K when I pulled it. But it had a few leaking gaskets and made a huge mess. Shouldn't leak anymore though now that it's all resealed. I haven't fired it up yet to confirm though.
@kevinwest3689
@kevinwest3689 27 дней назад
Short cuts can be expensive folks. But sometimes you get lucky. If you don't want to spend the money on the plates to cover the ports. How about tape. Also Easy off Oven cleaner Dollar general store is good stuff. But not for aluminum because it will look like crap after. As far as paint stick and last and not fade or dull EVER. Kbs Coatings is the💩
@TonyJohnson-t6c
@TonyJohnson-t6c 4 месяца назад
New subscriber bro!!🔥🔥🔥
@redgoatgarage
@redgoatgarage 4 месяца назад
Awesome, I appreciate that!
@Outdoors-ty8hp
@Outdoors-ty8hp Год назад
I feel like wd40 would be best for putting in the cylinders , being it’s a water displacer
@redgoatgarage
@redgoatgarage Год назад
That's a great suggestion. I went with oil just so it was thicker and would last a bit longer. Or maybe do a combination of both of them?
@mattnev8625
@mattnev8625 Год назад
You’re not worried about filling your intake ports with water?
@redgoatgarage
@redgoatgarage Год назад
Absolutely. I put towels down each intake runner. Then when I'm done I turn the motor upside down and spin the crank a few times. After that I'll put motor oil in each cylinder and spin the crank a few times again.
Далее
ХУДШИЕ ВЫБОРЫ в США
13:20
Просмотров 311 тыс.
How To Clean An Engine For $80 Bucks DIY
7:07
Просмотров 724 тыс.
How to check if your LS junkyard engine is good!
13:37
The BEST Way To Do A CHEAP LS Swap!
8:42
Просмотров 286 тыс.
Top 5 Mods To Make An LS Engine Reliable.
24:02
Просмотров 852 тыс.
JUNKYARD ENGINES! 6.0 vs 5.3 - Which is the BETTER Buy?
52:37
Honed cylinders or mirror finish - which is better?
14:53