Clifford Intake + Weber 38/38 carb on a 194ci Chevy I6 (3.2Liter) Running! 

The intake, carb, and headers are from Clifford 6=8. The carb is a Weber 38/38 and the guys at Clifford will jet it for you before shipping it just specify the motor. I also have a redline fuel pump meant to run with this Weber carb you can also get from Clifford. If you go to their website they do full kits with intake, carb, and headers. And even do dual carb builds and adapter plates for 4bbls. You will need the adapter plate to fit the ever carb onto the intake but it will come with the intake kit if you opt for that. I also recommend a heat shield mounted between the carb and the adapter plate in order to keep the carb from getting too hot. I had issues before I installed it where the car wouldn’t start and idle after sitting for 10-20min after running. After installing the plate I’ve never had this issue.

Thank you sm! I must admit though I am a bit jealous that u got a 250 cause mine’s a 194 😭

Both of the lines running to the intake manifold are coolant lines. One runs in the other flows out

The carb in this video went out because it was a cheap knock off. I’ve delve got a real Weber 38/38. Im not sure the exact Jet size but I ordered the parts from Clifford performance and they jetted the carb before shipping it. The high idle was an issue with the cheap carb and since getting the real Weber it’s been just fine and running better than ever! Thank you for showing interest and sorry for the late reply. I was trying to get the jet sizes from Clifford but they never got back to me on the specifics

I would imagine it does but mine went out a couple years ago and I converted to an electric fuel pump when that happened. I have a redline fuel pump and if you order an intake set up from Clifford some of the kits come with the fuel pump or you can buy it separately

It does close it just idles high when it’s not loaded but it sits around 800rpm if I’m remembering correctly when it’s under load. My dash went out so my gauges have been out for a while now but it has a lifetime warranty I just need to contact the company

And thank you!

cliffordperformance.net This should take you to Clifford’s website. They sell the whole kit built with the carb and with the right electric fuel pump as well as headers or you can get the intake. They have a good selection of parts for 6’s that’s where I got my intake manifold

@@McC_62 thank you but i have decided im goin to put a v8 and putting a new front end on it now

@@kadenmoreland7055 nice! The main reason I didn’t go with a V8 is cause 1 this motor has like 15k on it and 2 this car is my daily I have a couple other vehicles that are my families and I have a company truck for work but usually I drive this car

@@McC_62 i hear ya nice car though

@@kadenmoreland7055 thank you man!

Honestly I don’t know how much power I gained but right now I need to put a throttle cable in it because the original linkage only opens the carb about 1/3 of the way but it’s got more power at 1/3 throttle now than it did with the original intake and carb

This is a 194. Do you have one?