www.copblock.o...
HF radio receiver RP-2M, original military device in excellent condition, tested, correct, you get what you see on the picture, no antenna, no power
The radio receiver RP-2M was one of the first domestic transistor radios. It was produced by Elektronska industrija from Nis in the early 60's and built in its germanium transistors. The device is intended for receiving unmodulated telegraphy (CW) and amplitude-modulated telephony (AM) in the frequency range of the HF radio receiver RP-2M 2MHz to 12MHz. The receiving band is divided into three frequency ranges. It was powered by DC voltage from two dry batteries of 4.5V. The units of the JNA connection used this receiver as a stand-alone receiver or included in the Small Command-Staff Circuits (MCSK), usually for reception of the so-called. "alert wave".
The RP-2M receiver is a double superheterodine. The antenna signal is amplified in a two-stage VF amplifier and leads to the 1st mixer. The 1st mixer also provides a signal from a variable oscillator (VFO), which sets the operating frequency. The mixing product is 1.frequency (MF) at 1780kHz. The enhanced signal in the 1st MF amplifier is fed to the 2nd mixer and blended with a quark oscillator signal at 1500kHz. After mixing in the 2nd mixer, the signal is introduced into the 2nd MF amplifier operating at 280kHz. (Both MF amplifiers are with classic LC filters). From the 2nd MF amplifier, the signal enters the demodulator and with the help of the telegraph receiver (BFO), a controlled quark of 280kHz produces a NF signal, which is amplified in the low-frequency amplifier and played in the headphones.
The receiver is mounted in an aluminum housing partially resistant to water penetration. The set of receivers consists of: radio receiver, antennas (rod and wire), headphones and accessories for packaging and carrying. Origin: Yugoslavia.
17 сен 2024