Clutch and Flywheel replacement.VW Passat B6 1.9 TDI. 

Thanks 👌👍

Thank you 👌👍

thanks !

Sorry for late answer MILWAUKEE M12FIWF12-0 M12 FUEL 1/2" IMPACT WRENCH

Locktight already applied on New bolts

so was it? I'm curious since the same awaits me in a few days...

@@mithrilsk I still haven't got round to it...definitely need to do it soon. None of it looks difficult, just time-consuming.

@@dunebasher1971that it was! I recommend also replacing the crankshaft seal while already at it. Also I needed to order a new pin on which the clutch lever rests as it has a plastic component that shatters easily when the DMF fails. And just a side note I managed to get it done without disconnecting the driver's side driveshaft from the wheel.

@@mithrilsk Thanks for the heads-up. I'm actually finally about to do this. I've been advised *not* to touch the crank seal unless it's already leaking, and if it is, I'm going to need an engine support bar as well as the special crank seal install tool on top of the already-expensive crank seal itself. Or did you manage to fit the seal without the tool and/or without needing to drop the oil pan (hence needing the support bar to hold up the engine from above)?

@@dunebasher1971 the seal itself was really not that expensive and I've found a few videos here on YT of guys just pushing it in, no special tools. It did come with a special plastic ring to help lead it in though (not sure if all manufacturers provide it). I went about it a bit more elaborately using 3 screws with washers overlapping the seal - then I just tightened the screws each a few turns at a time until the seal was flush with its surroundings. The real thriller was the magnet for the crank positioning that comes on the seal - it obviously needs to be installed in the same position as it was before removing the old seal. That's why some recommend positioning the engine to TDC which I didn't do and just went by photos I took before removing it. The engine support seems necessary, however, since there is nothing to hold it in place while the transmission is removed. I should add that I still have a minor oil leak, but it seems to be coming from the valve cover and I didn't have the time to check on it properly yet.

"Yes, it's one of the symptoms of a bad flywheel. However, if you press clutch pedal, the shaking and vibration will either disappear or be reduced compared to before

​@@CarFixEasyThank you..

"If the clutch is still working, it means the crankshaft seal is leaking, but only if oil is definitely dripping between the engine and transmission. However, if the clutch is gone, that means the slave cylinder is leaking."

Hi. Tris is manual gearbox

Thanks for the reply! @@CarFixEasy

All bolts on the car need to be torqued up. 😀👍 I don't have this tool at the moment, which is why I tighten it by hand. But if you have a torque wrench, it would be better. Pressure plate torque: 20Nm.

If you car have same sound, it’s Flywheel problem. Better if you change all set: Release bearing, clutch disc, pressure plate and flywheel,

@@CarFixEasy thanks

Yes. Its absolutely same.

@@CarFixEasy my mechanic said it's either luk or sachs

@CarFixEasy ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-LC3pNM_Jj7g.html Its actually smooth. Very little sound from gear box side. What you think friend

If it just very little noise, you can still drive. Better if you make video how you press clutch pedal. This way you can see difference.. About flywheel brand, your mechanic right. LUK or SACHS best choice.

@CarFixEasy you can hear the sound in this link ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-LC3pNM_Jj7g.html Actually my car has very little run daily. I use liqui moly 5w40 oil. Which engine oil you use? Any diesel additives can you suggest? Thnx dear

Didn’t found any difference..

No, all working perfect 👌👍

Hi. If you have good tools and car not very rusty it take 4-5 hours.

Thanks

Originally there is Dual mass Flywheel. I fit conversion kit ( solid flywheel)

Not remember now but not more then £200

My English not very well 😃but next time i will try… 👌👍

​@@CarFixEasy❤❤ ربي

Salam menim arabam epc yazır qaza basan kimi onu neden olduğunu soruşdum ne olar

Ce are volanta? E alta marca fata de restul kit-ului sau ce? Intreb ca dupa ce trec ploile astea,vreau sa schimb si eu kit-ul cu tot cu volanta si nu vreau sa gresesc.... Multumesc! Deja volanta mea vibreaza de-ti sare cheia din contact....😁 Si inca ceva: e obligatoriu sa dau uleiul din cutie afara? Eu stiam ca nu e.... Abia l-am schimbat de 1 luna si parca nu l-as da afara...