CRAFTSMAN CHAINSAW BOGS UNDER LOAD - FIXED 

Mine kept dying on me. Your video saved me. I didn't buy the tool I just filed an old screwdriver and with proper twisting it moved. Thank you.

Bro thank you!!!! Wish I found you before I replaced it, cause that was def the issue! Lol Bless!

Good instruction. I'll need to learn to tweak the carbs on my saws eventually, I'm sure. They both run good now. Thanks for sharing!

Just the fix I needed and the link to the adjustment tool is very helpful too. Thank you!

Make sure when you adjust the jets that you have a clean air cleaner also it’s best to set more on the rich side rather than max rpm

Thank you brother Choking out on full throttle after replacing fuel lines. Fixed now.

Nice and short to the point! Thank you for not making a big production!!

Thank you sir! I ordered the tool kit...look forward to getting my saw back into fighting shape. Thanks again.

Special Adjustment Tool for a Special Chain Saw, but from the special factory, making a special design, couldn't manufacture for a flat blade screw driver. It's Special !

Hey, thanks man. FIL gave me an old Craftsman and said if I could get it running it's mine. This did the trick

I am gonna have to try this.. I just bought a Husqvarna 130 , maybe a 5 months ago.. Only ran about 8-10 tanks of gas through it, was cutting fantastic.. today, I am working on taking down a good size Silver Maple and it started bogging out when I started cutting. When I took the saw off load and revved it, it was great, until I put in under load again. I just cleaned it all maybe 2 days ago, so I know everything is clean. One question however, when you are adjusting the high speed screw, were you holding down the throttle? Or running at idle?? If I adjust the high speed, am I gonna have to adjust the low speed and idle screw as well? Thank you

I didn’t wanna wait for the tool or even buy it so I used a small drill bit to put a hole in that little screw so I could use a very small flat head

Maybe if you ever think about doing a video like this again show us everything such as what your adjusting

Love your lift! Wear did you get it? Video was great help also👍

Cool. Just picked one up. Barley starts and then dies. Just getting into it

Great video my jeans doing the exact same thing I was just wondering I did have mine apart and I did see those screws is there any way of adjusting them without that special tool?

Well you didn't show the adjustment screw, so not sure where to find it on a saw?

Adjusting should be the last thing after checking and cleaning other parts. Fuel filter air filter etc

I just got that adjustment tool last week! Mine needs it doesn't want to idle #WorldsOkayestFarmer

Me Chinese, me play joke: me put junk parts in your chainsaw. Good ruck, round eye!

Sounded correct to begin with.. Your going to burn up your engines doing this. Your chainsaw should bog down about 2k rpm under its maximum rpm.