This is so dumb. Thank you for making this video, I couldn't for the life of me figure out how to make it work. I finally just went ahead and learned how to use Orca slicer since their cutting tool is not only native but also much more intuitive and versatile.
This is cool for certain applications, but the fact that you can't delete the lower half is ridiculous. You'd figure the ability to delete the lower section would be obvious for a tool like this.
how your CURA ignores half of model while this model is not inside the borders. I can't slice my model CURA says about borders and can't slice it. Help pls
Howdy fella, I am brandnew to this hobby , ender 3 v3se delivered today still to open box and setup Q, when you download from thingyverse or cults3d they say model can be printed in any scale I.e 1:24 or 1:32 where do I set the scale after downloading the stl file Your assistance will be great fully appreciated (it's a slot car body)
I like it. Normally I use openscad and cut out a 0.1mm cube where I want to cut and use the mesh split model. This could be useful though. Now, if it could add connection points like a hole and cylinder so you can snap it together that would be even more useful.
@@3DPrintsNW sounds great except I don't know how to use meshmixer. The one time I tried it confused me. I will have to try again and see if youtube has some tutorials on it.