@@ericvauwee4923 the CBR 600rr has a 3 finger trigger plate on the camshaft. You can setup this engine using the dual wheel setup in the speeduino config. Need to remove one of the fingers to get a proper signal from the plate, I'm still not sure which one to remove. I forget how many teeth the crank has but it can be programmed into the config without physical modifications. The bike has VR sensors so you'll need VR conditioner to allow the speeduino to read the signal. To get proper flow values and latency values for all 8 injectors, I planned on sending the to snake eater performance to get cleaned, flow tested and a set of latencies produced. Snake eater has a machine to get you a full set of latencies so you can easily get the injectors dialed in and spend less time manually tuning them. I couldn't find any latency info for the stock injectors. Speeduino can run all 8 injectors in a staged injection process where it uses only the main injectors at lower RPM then gradually uses the upper air box mounted injectors as RPM increases. Look up the documentation on staged injection. I'm still learning more and the bike needs to be tuned in alph-n. Do not try to use speed density with a stock bike because with speed density you need an intake manifold to get a proper reading. With the standard ITB setup it needs to be alpha-n Join the speeduino group on FB and there's people who cab help you tune, diagnose, help with hardware, etc. This is pretty much everything I've learned so far in regards to the 600 RR.
@@clutchboi4038 thank you very much for your estensive response. We are planning to use this engine in a kart so it's Abit different from it's native habitat but yeah. We have an intake manifold with sensor. Thank you, I will join the group and check the info I can find in there.
Really impressive, it looks incredibly neat. Im at the start of an EFI conversion project and would love to know what kind of board you are using. I believe you are using an arduino Mega mini, but the PCB beneath it is simply stunning, could I get that PCB somewhere? Also, what kind of connectors are those? Very clean, congratulations!
hello the connectors are called FCI the boards are designed by me and you can find them at kptronics.gr ( sales@kptronics.gr ) or you can grab them from ebay ;) www.ebay.co.uk/itm/225138352068 and correct it uses a mega pro mini that runs speeduino free firmware
Can anyone tell me about the code disc ?. I mean the crankshaft position disc, how many teeth does it have ?. And how many pulse (Hz) can an arduino handle ?
Do you have the board files to make another similar? I'm planning to put my R6 Engine in a go kart. It would be awesome if i could adapt this board to fit with the build documents.
