Custom Fabricated Tractor Cab // New Holland 1920 

Thanks, I’ll try to do vids of the smaller details in the future a lot of viewers ask the same thing👍

I’ve done a couple of jd 5075 models ,I’d send you a pic if only I knew how lol

Thanks👍

Every one is a custom build they may look alike but they’re all different, no templates just experience thanks for watching 👍

Yes I install my own glass was tough at first but after a thousand or so it’s gotten easier 😉, maybe I can do a small video of a glass install on the next tractor, and yes a novice can do this you just need the right tool and patience

My cab’s start at 8k ,I’m located in newbrunswick Canada and service the Atlantic provinces unfortunately the tractor has to be here in my shop for fabrication

@@bradgraycabs ok, thank you! Keep up the great work

I never drain the coolant and i never get air pockets , I simply tie into the coolant system by whatever means necessary ,usually through a bypass hose then make sure reservoir is full then run tractor high idle until it reaches operating temperature then shut it down wait 10-15 minutes and slowly remove rad cap air will escape and reservoir will purge into rad, all will be good trust me👍 I’ve done hundreds..

Local glass shop, laminated 1/4” tinted safety glass same as what’s in your vehicle

There’s no brand name its a basic 12 volt setup radiator with an electric fan behind it

Cabs start at 8k

I don’t think it can be done to be honest

To bad you weren't closer I am looking for a cab for my 1720.

@@redfoot06 would love to help you out but tractor must be in my shop for fabrication thanks for watching

@@bradgraycabs No problem. I love your work. I'll keep Watching.

@@redfoot06 thanks buddy 👍