Hi, I would like to access the I/O or the DM area of a simulated CJ2M PLC (running in CX-Simulator). Do you have any idea? CX-Simulator manual says that it can simulate FINS Ethernet communication as well, but I could not set up. Thanks.
For my idea, first you should set up by following my video, configuring PLC as CP1L first. Once, it is connected. Then, you can change the plc to CJ2M.
@@ChunzPS Thanks. I know that CX-Designer and CS-Supervisor have direct interface to CX-Simulator. Sorry, I did not tell you, that I wanted to access CX-simulator from other Non--Omron software either via OPC, FINS or DDE. I had no success.
In this video, I showed the tutorial using simulation to connect CX Supervisor with CX Programmer without connecting the real PLC. So, you don't need to use any hardware.
