Cylinder head resurfaced in the Backyard? This guy is a genius!! 

Good idea only thing that would be better is making the sanding surface bigger so the head can be turned sideways to get a cross hatch pattern an help get a more uniform flat surface.

Just did this to the heads on my 97 Blazer. Perfect!

For taking off the exhaust manifold just heat them enough with a propane torch so the heat can expand the screw and get it to loosen easier

Take an old treadmill an electric one, get you a thick piece of flat steel the same length of the treadmill run your belt that you get made over the top of the steel and run a hose pipe over it or a garden hose with water and maybe put a little soap in it. You could use a parts washer pump and recycle the water if you wanted too it works great. just do not get carried away and cut way too much off of a head you need to mic it first. Whatever it is, you are resurfacing just make sure you do not cut too much off of it because it will do it really quick and that also depends on what grit sandpaper you are using.

Nothing like some little elbow grease.

Spoko, Kolejnym razem zanim zaczniesz to pomaluj powierzchnię czarnym nie zmywalnym markerem, będzie widać górki i dołki gdzie zbiera a gdzie jeszcze nie.

I can see by the comments that this isn't a video for those guys whose mommy cut the crust off of their bread

Have done something similar many times and never once had issues, just use common sense, Take your time

i have a question though, when you resurface a cylinder head, does it reduce the thickness of the surface, or it only removes the dirt?

Where is the shade tree

This will work if you are in an apocalypse type scenario if every machine shop in the world ceased to exist

Thanks for the video! What was the yellow attachment on the drill you used?

What grit did you finish with? 80 is too course for finished product

انگلیسی بلد نیستم بنویسم یکی.بگه این کاغد سمباده چی هسته ولی چی میزد روی کاغذ و میکشید لطفا جواب بدین

Where did you get the roll of sand paper ??? Thanks 🙏

Hello from Oamaru Sth island New Zealand. Do you advise to dress head gasket with Hylomar spray on prior to installation?. I'm replacing a gasket on my 2012 Nissan Navara D40 St-X Diesel common rail turbo engine

How do you ensure that the surface where you put the sandpaper is perfectly flat? Because if not, I think the whole thing is meaningless.

Is that a dual OHC engine? If so, what is the make and model? THX

How long did the sanding process take you?

OLÁ. Pelo que vejo, não sabes nem o que estás fazendo.

Please just take to a decent machine shop, this is stupid.