Hi Clara, thank you for the videos, I'm getting an alarm on the bcs100 when trying to do calibration. New sensor, New rf wire, check the quad cable and connector. Everything seems to check fine. But when trying to calibrate it give me a alarm: always hit board/cap zero. What does this mean. Any help would be greatly appreciated
Good morning Clara, calabration is perfect 3 step and quick calibration, replaced ceramic, capacitence amplifier and wire, will cut for a while then CYPCUT BSC100 CAPACITENCE DEMINISHED 512 alarm appears again. Solution?
Hi mam, i am facing top touch alarm issue in my machine very often without getting my nozzle touching anywhere. When machine travels from one point to another or accelerates, alarm comes , even when nozzle is 50mm above the sheet material. Pls help me out Waiting for your response
@@ClaraChai tried changing rf , ceramic part, signal cable, bcs amp Still same issue observed randomly, sometimes it comes no. Of times in 1 minute and sometimes work 2-3 hours without alarm