Daikin Monobloc Heat Pump Wiring Video. 

Daikin wiring - ohh boy, just why do they have to make it so complex. Heating heat pump manufacturers for me all day long. I will save this video for this unfortunate day I have to work on Daikin again. Keep up the vids.

HMI = Human machine interface. Unbelievable that it's still called a MMI by Daikin in the UK. Emilie is the best HVAC presenter I have ever seen anywhere. Good work! Thanks.

Well done guys😃

Great video. Being an NICEIC approved installer looking to install these units please keep them coming as this helps us decide if this is an area to want to work in. One item you have missed off the consumer unit is surge protection this in now a mandatory requirement.

Very well explained dear q

Great video I think that Daikin need to look into having terminals for secondary heating pumps if they require you to have a buffer so you can still use there own controls. Using a on/off thermostat like a hive I have found to be much less efficient as there is no hysteris and causes the heat pump to switch on/off way to often. I have now switched to pure weather compensating the heat pump and seems a lot better once you get the curve set right.

I bought the Daikin Monoblock 6Kw today and will be able to install it myself thanks to your detailed videos! Super detailed explanation, professional at work! Greetings from Germany!

Brilliant video. I wonder could you make a video on wire connection between daikin Hest pump and hive controler . Thank you

Great video! Do you have to use the Dakine Madoka wired thermostat - or am I able to wire in another thermostat to the MMI that offers me more features? e.g ecobee.

did you do a video on the basis of having a preplumbed cylinder?

That was a funny intro 😂

Hello. I have a question concerning Wiring the control panel. If I take of the part with the screen there is a green bar with 4 connection points on the left. If I look at this green bar where is the point to fix pin 15 and 16 coming from the outdoor unit.

👍💪

I’ve a Honeywell home system of smart TRVs that act as independent zone valves if one opens calling for heat, power is output to my existing gas boiler. Octopus Energy will in the near future be installing one of your heat pumps. What I’d be interested to know is will my Honeywell smart TRVs work with your heat-pump

In my country Daikin instillers telling me that they don’t put buffers any where that they instal pump? How is your experience? Isn’t that bad for short cycle for compressor? Thx

Is it possible to make a video about FCU?

Hi Emilie, great video! World be great if you helped me with an issue on my 3m..... my electrician pulled only 1 cable 5×4mm2, and only 1 30 Amp FI. There is no 2nd supply for the Backup theatre..... can this be right?

I wanted to connect my relay to control the heating, but I have 230V on the pin 35 and 0V on the pin 30. Do you have the same values ?

@ecobubl have you issued the video on the preplumbed Daikin tank yet 5:00

Hello to All. Since 3 weeks I operate a Daikin altherma 3 M and use the basic Set up for for floor heating System. Because I have a house that is not very well insulated I need 33 degree flow temperatur and return is 30 degree. The flow rate is 22 l/min. The average outside temperature is 7 degree. Right now i am quite disappointed about the cop as well as the daily performance. The daily performance is only 4.0 The power consumption while is 0.9 kw only. I do not know why the machine has a really bad daly performance. I hope that someone could give me an advice.