Daily Dentistry Tips and Tricks!!! 

Thank you for the kind words doctor!

Thank you.. Keep watching!!!!

Thank you Kashmira Ali...

Thank you doctor..Will try and feature as many as i can

Thank you

Thank you so much for the kind words doctor!

My pleasure .. Keep up the good work.

Im wondering if lipsticks can be used to locate pressure spot in complete dentures instead of using bossworth.

Thank you

Thank you Dr Shreyas srinivasan

Thank you for the kind words doctor!Hope this helps !!

Good to see these tricks will help everyone

Thanks you..do try them

Thank you

Yes. There's a lot more coming up.!!!

Glad that this could help you

Surely doctor..many more to come

Hello Dr Malik. The issue is more complex than we think. Firstly, since we are playing with microns , it is often difficult to judge how much space we have. To the human eye, 2mm and 2.5 mm would probably appear the same. The best way to avoid this is to use calibrated depth cutting burs where you know the exact amount of reduction you do since the burs are measured and calibrated. Secondly, the issue also lies in manual impressions, manual lab steps like die pouring and articulation,etc. Hence , the advent of digital technology today like intra oral scanners where you can actually see and measure on screen how much clearance you have created and also maintain the accuracy that we need...

Sure Dr Shweta. Stay tuned for that!!

Thanks for your inputs doctor.!!Well chip off will happen if there are too many vibrations (faulty air rotor) or too much heat generation because of friction caused due to dry cutting.The heat will cause micro cracks which can result in chipping.So as long as your handpiece is fine,you are using water and you are not using undue force,you should be fine...

Hi.. It basically makes easier to transfer the gap under the pontic to the lab so that the technician can add ceramic there and close it.!!

Using a tapered fissure bur would mean an increased risk of opening up the contact ..

Thats quite a common problem with multiple units. The best way to handle it is try not to have massive undercuts in the first place.!!! If you do end up having some, locate the undercuts on the intaglio surface of the abutments by using an indicator dye and try to remove them systematically.

Chairside Education what can you suggest as alternative if i dont have dye thanks