DDJ FLX10 & MAGMA XXL PLUS CASE 

Thank you.

Hello. What I used is 4.5mm and it's perfect for the small headphone jack. You can also get a curved jack if you wish otherwise 5mm should be good.

Thanks man! Gotta Represent CV :) With everything I'm around 23 pounds which is very light. I'nm very happy. I even had a few Dj's do the exact same thing. Good luck with your project.

Hi. I find only aftermarket power supplies get very hot. The OEM ones don't get hot and after a 5-hour gig, I lifted the controller and noticed it was cool. The MacBook usually stops getting hot once the battery is at 100%. You can test it as well to see.

Grazie @@djab203

Prego!

Thank you. I would suggest going into home depot and getting something similar to what I used but if possible a bit ticker. What I used was 4.5mm and I had to cut it.

@@djab203 May I ask what exactly it was that you used? I tried to search on their site for something similar and I was not having any luck.

I don't recall the exact name but I believe its the Eucalyptus White Hardboard

​@@djab203 Thanks a million! Excited to give this a go.

It's the Griffin Double Piano Keyboard & Laptop Stand 2 Tier

I have been doing this for a while and never had any issues. I used this mic system under SX2 1000srt SR2 and now FLX10.

that's what's up! which mic is it? @@djab203

@@djphilsantosIt's Shure BLX Dual Channel Vocal Wireless w/ 2 PG58 Mics

It's the hard foam that comes with the flight cases. If don't have any you can use the kneeling pad foam. Home Depot and Amazon have them. Also, watch my custom rev5 case where I did things a little differently - ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-Lh-DShbXwXg.htmlsi=LydktRkr5Beb9MGf

No. I find only aftermarket power supplies get very hot. The OEM ones don't get hot and after a 5-hour gig, I lifted the controller and noticed it was cool. The MacBook usually stops getting hot once the battery is at 100%. You can test it as well to see.

Thanks I’ve just bought the same controller and case so going to give it a try

@@petereldridge7773Very nice! So far I'm very happy with my setup. The only warning is to be very careful with the leg of the case. I was being rough and damaged mine but I'm still using it without the legs :)

4.5mm

@@djab203 thanks for the reply. Do you think 1/8th inch is too thick? I found 1/8th inch particle board on amazon for cheap. Also do you think foam will work instead of wood? I also found 5mm foam sheets

​@@Dannyfr33sh 1/8 is actually a little over 3mm so you may have to double it. I recommend wood or particle board. The foam sheets have always been crappy from my experience.

@@djab203 so a 1/4 inch will do? because Amazon is showing me in inches and not mm

@Dannyfr33sh 1/4 is about 6mm so yes it will work. The bottom and top foam will compensate for it.

It's the Magma Carry-Lite XXL Plus DJ Case (MGA41102) Amazon - a.co/d/cjJN2Wp

It sold a few weeks ago

Sorry It sold right after I posted this video