Defender Puma Axle Refurb Complete. New Bearings Seals Brake Calipers and paint. Land Rover 

Thank you for the video. I'm rebuilding the suspension on my defender and your videos are a ton of help for a first time defender owner!

Great video! One tip when you do the video on replacing bearings, you should fit the purple spacers then check the end float with a DTI gauge. Depending on how much end float you have left you then fit the yellow, red, blue etc. spacer. There is a good table in the Haynes manual. My experience is you do need different spacers even when using the same hub as the tolerance is in the bearing too. I like to see the hub and disc continue to spin after turning, yours looked a little tight but could just be the way it came across in the video 👍🏻 Another tip is to fit the pad pins from inside out, if you need to change the pads in future and the pins are stuck it's a lot easier to tap the pins with a punch when fitted that way. Also easier to undo the split pins when you can see them 👍🏻

You wont believe this but this song is playing everytime i start landrover training hahah

Nice job but for first timers, it would be good to tell them to degrease new discs before fitting new pads.

Where did you get the halfshafts?

....looking good....you've obviously learned a lot from my videos....LMAO!!! :)