Had to come back and give your video a thumbs up. I never soldered a pcb board before, and after watching this video I bought all the supplies and made 2 of them and they both work as anticipated!!! Thank you soo much!!!
Hi. It worked perfectly. Thanks for the video. I have some questions. 1)When I’m using this with some battery is this module drain the battery fast?? 2)In my case how can i use this with 10v
I want 5 minuts time delay. Will it work perfectly if power has gone for 2 to 3 sec. and come back.i mean again 5 minutes delay. What is the full discharge time of capacitor ?
Nice!! I am just looking circuit like this.. could you pls able to suggest me to buy the circuit as my expectations as follows? I want to run dc motor repeatedly in particular time interval like dc motor should be running 10 sec and should be not running after 10 sec it should be repeatedly like this....
please, explain me why Q1 it emisor is connected to +12 vcd? I think the colector pin should be connected to +12vcd....ok, ok I checked the dt SHETT and this trasistor is PNP, in the schematic link was drawing like npn.
To extend the relay activation time and adjust the delay, simply modify the capacitor without altering any resistors. A higher capacitance value will prolong the on-time delay, while a lower capacitance value will result in a faster relay activation.
please make .... एक एसा सर्किट बनाओ सर जो लाइट आने पर कुछ समय के लिए ऑन हो जय और कुछ समय बाद बंद हो जाए मैन लाइट के लिए । जैसे लाइट आने पर सायरन चालू हो जाए कुछ समय के लिए
I am very very sorry for that mistake. Solution here check out this diagram.photos.app.goo.gl/hgrMFysKQ325NJ5d6 this the relay connection diagram. Follow this step. You will use this circuit on a speaker protection same setp.