Design, Calculation and Simulation of Electric Vehicle on MATLAB Simulink 

Hi, MATLAB The Signal Builder block has been removed. how can we use signal editor in place of signal builder. Can please make a video.

You add current sensor, PS-Simulink block and scope to the H-Bridge converter in the later part but you did not show it. Take note of this

Where ia Thr battery?

Can you make EV charging station using solar, grid, and battery bank

What is the value of air density

Signal builder is not there wat to do !!! How that graph comes out automatically??

what information did you yield from this though? what knowledge was gained?

Hi, please I did not see you add battery pack like you said it is one of the requirements.

What are all the existing methods in this simulation

there is no option of signal builder in matlab

U changed some stuffs in the model later, but didn't show what u changed... why make this kind of tutorials.

At some level this might actually be helpful.🚕

Hi What is the version on MATLAB used?

HI, thanks for guiding step by step of this model. I would like to know if you made any changes in the model parameters, coz I followed exactly the same steps but my model is unable to reach the reference speed as shown in your signal builder and the final results. Also I see you made some changes in your model at 13:26 , is there any important parameter changes inside the blocks? if yes, then please specify. Thank you so much