www.carolinash...
In this video, I try 2 different methods to create an inlay on a cutting board, in the first half of the video I use Total Boat resin poured to the cnc cavity.
In the second half I do a traditional inlay with a piece of walnut into a piece of countertop that I bought at Home Depot. This a tried and proven technique using Vectric V-Carve software check out this video for more information • The VCarve Inlay Techn...
For me, the learning was about the inlay and not so much about the cutting boards, which is why I went out and bought a few different cutting boards to experiment with.
for support and voiced over version check out
/ diresta
Thank you
www.carolinash...
www.titebond.com
www.shopbottoo...
www.vectric.com
20 авг 2024