DIY Euro Hinge Jig to install BUDGET Hinges! 

@@WarlockUberElite sure, my cabinets are frameless and the doors line up with the bottom of the cabinet frame. So I just measured from the bottom to the center of the red piece. I think 3" or 4" depending on where you put the pin in the hole drilling jig. Basically the center of the red jig should line up with the center of the hole that is cut on the door.

@@ClassicActWorkshop Great, I will try it this way and see the results. Many thanks 😁👍🏻

@@WarlockUberElite good luck. Never hurts to test on some scrap before drilling into a finished cabinet too.

Yup, correct. The milescraft is adjustable from 3-7mm I believe.

@@ClassicActWorkshop Ok, so the closer it is to the edge ( 3 mm ) the more adjustment you have ? Thanks.

Well I was targeting a 1/8" gap in all my doors. The hinge said it should be 3mm. When testing, 3mm was right on the limit of getting to a small 1/8" gap with the hinge adjustment. So 4mm or 5mm just makes sure I have enough adjustment.

The hinge has adjustability, but still needs to have the right range of adjustment to make sure the door gap is right.

@@ClassicActWorkshop Ok, so you had to drill the hole a little further into the door, now I get it. Thanks for that. I know I have a mistake somewhere in doing this. 🤪