Pro Tip: If you are servicing, upgrading or just pulling one headlight, it is not necessary to remove the hex screw behind the wheel well on the opposite side of the bumper (see <a href="#" class="seekto" data-time="526">8:46</a>). There is plenty of room to remove the 10mm nut on the bottom of the headlight mount being serviced by just sliding the bumper forward about 4 inches to remove it.
What did he say <a href="#" class="seekto" data-time="265">4:25</a> into the video? My car was missing that screw so I was wondering what it held together.
@@fbsRoman спасибо вы как раз вовремя вот только собирался их делать но в интернете нечего нет Мне сказали что нужно снять сам элемент зеркальный и там уже по ходу
@@user-es5ne5hs9t На здоровье. У меня была проблема с зеркалами - они очень туго складывались и даже не всегда до конца. Я сначала пробывал пробрызгивать их в стыки и щели. Было 0 эффекта. А потом, как написал выше - сложил в другую сторону, открылось отверстие, туда я и побрызгал. После этой обработки уже несколько месяцев закрываются как новенькие :)