DIY Installing a Minn Kota Fortrex 112 

Instead of drilling more holes in your boat. Drill the holes in the Minnkota bracket to match the Motorguide bracket. Then you can use your existing holes in your boat.

Just bought a used boat with this TM already on it. The front of the TM mount hangs out past the front of the boat 3.5" which hung over the first dock a pulled up to and when stepping back on the boat I thought it was going to break the mount. Along with that the prop or shaft side both interferes with the front nav light making it unusable. Look like I'll be moving it toward the back a few inches...oh what fun.

Thanks for the tips guys. I will be installing my new Fortrex 80 tomorrow

Funny how they didn't show these guys sticking their arm in the hole trying to hold the nut with the wrench while guy on top tightened the bolt.. you edited the funniest part

Good video. Nice demonstration. Thanks.

FWIW they make long drill bits. This makes drilling with the bracket in place much easier.

90degree drills are useful too

Lol wow, that wave at the end soaked him! Didn't look like the wave was big either.

Looking to install my fortrex without a plug and was wondering what they used in this video and where I can buy it

I need to replace tHe brush house assembly on my fortress. any videos on that.

I see a few of these videos and nobody talks about sealing the holes that are no longer used. Is it necessary? Seems you would get water in there and the fiberglass would weaken.

Side plate on fortrex removes to show mg hole pattern.

Bought ours brand new and it turned out it didn't come with a bowhead stabilizer I believe it is called! The two black triangles that the trolling motor head goes over; ours come off easily.. Too easily! I don't know if we messed up or the factory didn't include all the parts or what.

Disconnect the Motorguide from the Gator mount before removing the mount.

Heard of any problems with the mounts on the 112 fortrex? Know a few guys who have had issues with the mount not holding up (most likely due to the extra weight of the 112's lower unit).

In the ca delta more guys go with minkota super weedless the Motorguide don't hold up as well even seen guys put a weedless wedge 2 on their Motorguide s

What was the piston called they put on?