ELLO&ALLO Stainless Steel Shower Panel Tower System, LED Rainfall Waterfall Shower Head 6-Function Faucet Rain Massage System with Body Jets. HandyTF: handyTF.com
Helpful video thanks. BUT you made some simple and potentially very costly mistakes with the wall plugs. Never knock them into the wall with a hammer directly or you could smack the tile enough to smash it. Place the tip of the screw into the plug to knock it in when you get close to the tile. Either sink the plug beyond the tile or use a slightly larger drill bit at the start of the hole to accommodate the head of the plug, otherwise when it expands it can crack the tile. Finally, either set the torque really low on the cordless driver or do it by hand.
Can you post a picture of the instruction that have the distance between the holes and mounting bracket locations, and sizes of the fitting and hoses that were used? Please and thank you.
The light is powered by battery, no wiring is required. The button on the side is used to turn on/off the light. The pain is when you want to replace the battery, you need to take off the whole unit.
@@anthony402 you will have to take the unit off the hook. Hold the shower unit and pull up to unhook it. After you do that, have someone hold it, while you trace the wires are the back, the battery should be in a black protective covering be careful not to damage any wires. After you replace the battery with two AAA I think, then you’ll see the light in the display, those batteries activate an actuator that allows the hot water to come out
It looks like you need the shower panel to get the water supply positioning out of the tiled wall and to have ot installed as per your desired height on the shower wall - otherwise you may be forced to install it at an inconvenient height. Instructions mention this, which means that you need access from behind shower wall or build shower walls after you get your shower.
Hmm, bottom bracket location seems to be tricky / as the routing of the 2 water supply connecting tubes is not easy to ensure a flush installation Video shows several holes drilled before I guess at a less than perfect location… Best location of bottom bracket on the panel itself should be higher…