Dream project. I've wanted to make a rack since high school. Seems u can make any structure after a build like that. I'd be proud of my craftsmanship and ready for bigger things. Wish I had more metal experience
If, I'm following right, you did 50mm/ 1.96" spacing on the uprights front and rear face. What hole spacing did you do on the sides starting from the bottom? Thanks! Great work!
Good build build m8 i am going to build similar just your thoughts if you don't mind . i was thinking using mild steel hollow square tubing 40 x 40 2mm wall .not quite sure of integrity swl of weights for the rig any ideas
Great job, well shot and edited. I am building a wall mount rack - how did you go about lining up the holes front/back? Also, what spacing did you use?
I set up my bench vises to be centered with my mag drill, so that every hole was always in the center of the tube. I can't remember the exact spacing off the top of my head (it likely shows it in the video) but I think it was two inches.
This really wasn't meant to be a "how to" or instructional video, so I never bothered to write up all the detailed info for the purpose of sharing. I can tell you that the dimensions of the rack are available on Rogue's website (which is what I used for reference).
I am sure about the equivalent gauge off the top of my head (everything here is measured in millimeters) but the wall thickness of the tube is about 4mm thick.
