No video :(

DIY Suspension Lift Nissan Terrano / Pathfinder WD21, spring spacers + torsion bars adjustment

Подписаться 450

Просмотров 20 тыс.

50% 1

Here is a DIY suspension lift on my WD21 Nissan Terrano.
I used coil spring spacers made from old tractor tires in the rear and torsion bar crank in front. Why those spacers? Because I am cheap! hehehe. A more suitable material would be a machined engineering plastic. Unfortunately I do not have access to those.
Feel free to comment below. :)

Опубликовано:

14 июл 2021

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 43

@saintpeterson5275 3 года назад

Next video request: How to adjust fuel-air mixture screw and idling screw.

@trailhuntersph 3 года назад

Thanks for the request, I'll make one this week!

@andrewfaltado2594 Год назад

Good morning sir. I've watched this vid before. Ano pong sukat nung spacers and how much for the fabrication? Thank you!

@Panda-vx9cb Год назад

Gff siz OD=mm? & ID=mm?

@geraldtec158 2 года назад

Thumbs up. Still wonderin if 8 have to change anything in the front suspension to fit the 285 75 r16 tires. With 16x10 dimensions😂

@trailhuntersph 2 года назад

285-75-16s are almost 33" in diameter. I saw a guy fitted 34" tires on a nissan pathfinder with a few fender trimmings. I also read somewhere that 33s can fit if you remove the fender flares.

@geraldtec158 2 года назад

Thank u sir for noticing.

@AntonioUy 2 года назад

What is d height in front & back 2 inch both, y not 2in front, 2.5 in back it can be lowered if there is load

@trailhuntersph 2 года назад

The tallest rubber spacer that can be made is 2". I guess that will be enough since I only lifted the front around 1.75". lifting the front to 2" will put strain on the suspension and steering components.

@lemonlaide7999 Год назад

Pwde rin kaya magpagawa sa rubber bushing fabricator ng rear bump stop ng terrano?

@trailhuntersph Год назад

pwede naman, dala po kayo ng sample. Actually sa akin, tinanggal ko yung bump stops. Since lifted naman yung terrano ko and need ko maka laro yung suspension pag nasa trail.

@johnsaints5505 2 года назад

Sir good day to you. Where can we source surplus torsion bars?

@trailhuntersph 2 года назад

Look for terrano/pathfinder wreckers like Ace Torno, Jop San, Yeoj Nicolas in FB Messenger.

@oliviazafe6870 2 года назад

Hello sir, i have an issue with the Terry rubbing its front tires under the fender. What would be a modest lift height? I have 31x10.5xr15 tires. If i place spacers for the front, what would i use for rear wheels? Could it be fitted with shackles? Thank you!

@trailhuntersph 2 года назад

NO need for spacers with the front suspension. It is adjusted by tightening the torsion bars. Shackles are used for leaf springs suspensions. Terranos have coil springs in the rear and spacers are needed to add ride height. I lifted mine 2" in the rear and 1.5" in the front. No rubbing issues on 31x10.5x15 tires.

@timothyjamieson1282 2 года назад

Spacers are illegal in most countries to raise vehicle height. This is dodgy as hell! Get the proper springs made to lift it safely so the Terrano doesn't try to kill you!!

@trailhuntersph 2 года назад

@@timothyjamieson1282 I'll take note of that. Thanks!