DIY tire Inflator and deflator system part 1 (EASY) 

Good simple to follow video 😊

I clicked for the diy. I stayed for the flag! 👍😉

NIIICE! I built my own simple hose setup that's only a single tire at a time (for my UTV) and I also added a "Nigo Industrial Co. Air Brake Air Tank Drain Cock Ground Plug Shutoff" so I can deflate the tire without having to connect or disconnect any fittings. I also used a Longacre gauge because I read they were very accurate. I keep learning about new ideas all the time. The absolute biggest benefit of creating my own hose/fittings setup is the ability to inflate/deflate my tires without having to turn the air compressor off, walking over to the tire to check the resting PSI, then walking back to the air compressor and turning it back on.

Very nice video. Can you give us a update vid on how its preforming a year later. Oh two bits of advice you really can do without the thread sealer (yellow paste) as it does exactly the same thing as the Teflon tape lubricates the threads and seals them. second if you warm your hose with something like a hair dryer on medium or even low heat it will expand enough to go over your barbed fittings and will shrink back down to size when they cool.

Nice .... what was your total cost?