Can you go into more detail when would you use certain settings ? What’s the MHz setting used for & what is single/double/triple best scenario to use that settings for & what is the repeat mode do?
Question, lets say that i want to do a highway linear mapping with L1, assuming the distance is 1000m, the start location has ASL altitude of 400, the end location has ASL altitude of 200. Obviously, if you take off at 400m ASL and flying at a fix AGL altitude of 100m, when you get to the end location, the height difference would be 300m. How would you recommend to do the flight planning? Use DJI Pilot Linear Mission? But Linear Mission doesn't allow you to have altitude setting in a single flight right?
Good morning sir/ma, please I need your assistance on Lidar flight mission upload, I just got a matrice 300 with Lidar camera whenever I wanted to upload a mission it will be complaining of RADIUS ERROR. Please how would I resolve this problem, or is there any settings that I need to do before I press play botton? Pleas I need a way out thanks.
It would improve the overall absolute accuracy of the point cloud. The reason I showed the cross section is to demonstrate the fundamental error generated by the sensor. Lets assume a smooth surface like a roof, if the surface variation of the roof was ±5mm, in a perfect sensor that's what you would expect to see. With the cross section, there is a ± of 7cm. This is the fundamental ranging error in the sensor. So any measurement you would make with the L1 would have a ±7cm error minimum when citing a measured result. If that is acceptable to you or your customer then the L1 would work for you. If not then you would need a better sensor. I hope this helps. Cheers!
It can work in PPK mode but having the DRTK2 simplifies the post processing work as with the DRTK2 you are able to see the correction data quality while flying and once done, you are guaranteed a strong PPK data.