Great tutorial! I have a question... I have created a [20x20] matrix in WLED using two vertically stacked [10x20] arrays. The first LED in each physical array is in the Lower Left corner and goes Up and is in a Serpentine configuration. This works perfectly in WLED! All demos including Scrolling Text work great. I'm now trying drive this display using Jinx through the DMX interface. Jinx Can successfully communicate with my device...and send data. But I can't get the mapping correct. I have tried many different configurations with many variations, here are two: 1) Three Universes: 8x20x3 = 480 channels 8x20x3 = 480 channels 4x20x3 = 240 channels 2) Four Universes: 10x10x3 = 300 channels 10x10x3 = 300 channels 10x10x3 = 300 channels 10x10x3 = 300 channels All have holes in the resulting display (I can be more specific if anyone wants the details)... or wrapped mapping... also, X and Y seem to be reversed. Is there any guide for DMX mapping in Jinx with WLED? Should this work with the physical layout of my matrix? Are there physical matrix layouts that WLED supports that cannot be represented in Jinx? Any help is appreciated...
If you don't mind, please show your controller connections and the sketch. I am using an ESP32 with bluetooth. I can connect to the Jinx animator but I am having trouble with the ESP32 outputting data to the 16 x 16 matrix, even with the pinmode assignment in my sketch.
Hi Keith, I don't have a sketch for this one I am using the WLED github.com/Aircoookie/WLED/releases which has a binary that you just flash to your ESP32. Pretty sure you can configure your output pins once it is flashed. As far as I know, it only supports wifi, not bluetooth. For my project, I used a ESP01 and there is a driver board specifically for this module so there isn't really any wiring involved.
hey i got this program to work but I'm quite sure i am doing something wrong in the setup. I set up a grid of 32x16 and I couldn't get it to send that many channels to a single device. I ended up cheating and creating a separate device with the same ip address for each universe. Is there a better way?
@@JWNZ thank you! I followed your instructions, I've tried it but only the first patch 16x9 works for me, when I patch the second 16x7 it patched but the sequence of the led is not correct, ang some led don't lit
wondering if Jinx can be integrated into my setup. - I run DMXis inside Ableton. - the DMXis controller to my regular lamps - WLED strips running independent effects. could I combine Jinx and the DMXis plugin to work as one universe? And Use the DMXis to be the master (to control tempo and trigger different effects for Jinx > WLED)