Drum Bus Magic 

Let’s go!! Appreciate that 🙏🏼

Thanks for the feedback!

🫡

Apparently with ProTools you don’t need one. Jaycen Joshua just uses a Spectral Analyzer plugin after his initial NLS Buss chain to visually see which side the drums are leaning towards and then he adjusts either the left or right channel with ProTool’s pan knob at a value of precisely 86 to get them straight back down the middle. There’ll still be some width afterwards but he says that is an INTENDED effect of the NLS Buss trick. Hope this helps!

Also, were you intentionally running the SC filter? If so, what were u running through it? Thx dude

I have the compressor set to Stereo instead of Dual Mono (located underneath the meters). This makes it to where the knobs on the left control everything. The knobs on the right are useless at that point. The parameter link feature would only be useful if you wanted to A/B between dual mono and stereo. If you were going to switch back over to dual mono, the parameter link feature would be useful to have the same settings set for the knobs on the right side because now they have an effect on the right signal. The sidechain filter is set at 20 Hz (located at the bottom of the plugin). With this activated like it is, the compressor will not be triggered by anything below 20 Hz. Hope this helps.

in a major way!! Thx again.@@mixwithjerry

Neumann TLM-103 -> Avalon AD-2022 -> Audient iD-44 with EQ, Compression, and De-Essing done through plugins.

Thank youu❤!

Clearly stated that in the video