Dryer vent through brick ( tips ) 

Wow! You got right to the point on this, good job

Rent a Hilti with core bit, I did today from home depot, such a clean cut and still a lot of effort.

Exactly what I need to do. Thx. Watching from Ontario Canada

Doing the lords work. Hole-y work. That’s a pretty wide diameter for that floor joist tho, hope that doesn’t sag much

Can you used a plastic pipe through the wall as a conduit and then run a ridged metal aluminum pipe through that and fill the end gaps with silicone? Would that hot aluminum cause the plastic pipe to melt? I wonder in case where larger bricks are used, and so some Cement will be needed. The ridged metal aluminum I have is thin, and so want to protect that metal.

Thx I have full brick 1984 build need to exhaust microwave vent

So……how do you clean it without being able to take the flappy-dos off?

Does it matter whether you drill the screw holes before you drill and chip out the big hole?

What’s a good external sealant to use

Fighting the pipe

Does it matter how high up the dryer vent is? I want it have it come out next to my basement window but it would be a couple inches from the ground. Is that okay.

Why not just use a masonry hole saw attachment for the brick and normal hole saw bit for the wood. Would have been done in minutes.

what size dril bit is this is it 3/8 ??

How long did it take you to cut the hole?

Lucky you didn't catch those cables

Thanks bud