[Dump] Use the aluminum bridge to transport the backhoe and replace the upper support. 

0:00
Hello, we have 963 subscribers right now, everyone's good buttons and comments are encouraging video production, thank you 👍
This time, the backhoe will be forwarded to repair the dump truck, and since the "maximum load capacity" is fixed for freight vehicles, it is necessary to strictly adhere to it. The "backhoe" in the video weighs about 3000 kg, but the "maximum load capacity" of this vehicle is 3500 kg, so an "aluminum bridge" can be mounted.
0:52
For safety reasons, it is recommended in Japan to use aluminum bridges to load and unload machines.
However, if you do not install the slip stopper, it will lead to an accident where the aluminum bridge falls, so we will process the vehicle side a little.
1:05
Place a place exposed to sparks with a "wet towel, etc." so that it will not be affected by heat.
1:33
Use "high tension bolts" that are sturdy to prevent slippage.
1:38
When unloading, use the arm and soil removal plate slowly and be careful not to tilt the machine too much.
1:51
The rear gate of the dump truck is opened and closed by the action of the "upper holder" and "lower holder". Since the upper holder on the left side is damaged, cut it with acetylene gas and attach a new one.
3:37
"Reinforced upper holder" is set for "upper holder", and it can be attached more firmly.
Thank you for watching and please subscribe to our channel.
#Details in the summary section
#dump
#Backhoe

Хобби