I'd have preferred yellow LEDs like under the wings in the rear fuselage. Also would have liked an installed Radio channel to turn OFF the LEDs. Yeah I know you can get an RC switch but would have been a feature if installed by the manufacturer. I still like my old (2020) original V1 Tundra. IIRC I paid $179.99 USD for the V1. The Tundra V2 (PNF) Purple/Gold still sells for $179.99 USD. IDK... $90 more for LEDs seems a bit pricey.
This video helped me to asamble this plane but the explanation could be better for new pilots like me. Installing the springs was not explained on the video I had to figure out on my own. Elevator soport bar was not explained also setting the receiver was not explained eather. I strive me from 1 to 10 a 6 +
2 года назад
Good feedback, I'll endeavour to do more in my next video. Thanks.
No info for radio setup with plane. I setup my Night tundra with my DX9. I have no proportional flaps 3 points 0 deg.s 45 and 90. Also the motor reverses with full flaps when I take throttle to minimum. Found that out when the plane nose dived on landing entry.
2 года назад
Wait, you esc fits into rev when you have your flaps down? That sounds like a mix issue in the radio. For me I set all my expo to 30% and then weights are low 70%, mid 85% and high 100%. Just bit of down elevator on the flaps. Which could be your esc reversing issues. You might have a channel crossed over. I have a DX9 and could attempt make a model. What RX are you using?
@ The receiver is a Spektrum AR620. Flaps are on channel 5 and light channel 6 of receiver
2 года назад
@@barrettfanning6746 Are you running a LED switch? Because stock there is no switch. You might have the reverse esc on channel 6. The LED's just power off the JST connector.
