Easiest way to remove your civic engine 

Great video man, very helpful. I don’t have a lift but I went out and bought a shop crane and vender blocks, not sure why it’s so hard for everyone else to suck it up and lay on the ground for a minute but I’m sure I’ll be able to figure it out with little to no excuses. And please, if you don’t have a lift, please don’t get upset with people who do. It takes years of rolling around under the security of cheap Jack stands, doing just about whatever you’re asked, before you can acquire a 2 post. Grow up. Thanks again man

If only I put in the same amount of effort I put into learning this into school.

“Basement car builds”. Video starts with car a lift 🤔.

I appreciate the no-nonsense helpful way you made this.

the fricken music kills good videos like this.

I guess it was a lot easier for you as you had the car hoist, a luxury most people don't have. Nice video though. Thanks

With a lift? Disconnect all coolant lines. Unplug the wiring harness connectors and lay the harness on the firewall. Disconnect the fuel lines. Disconnect the exhaust from the manifold. Disconnect shifter linkage and clutch line. Disconnect the tie rods only. Remove the calipers and bungee them in the wheelwells. Remove power steering lines from rack. Take out all the K frame bolts. Set the car down. Pull off the left and right motor mounts. Take the 3 nuts off each strut. Now lift the car up. The front wheels, struts, K frame (subframe, all transverse mount subframes are shaped like a K, they've always been called a K frame but not so much on the RU-vid.) The whole subassembly comes out much easier and faster than trying to separate transmission or motors and other parts. Now you can clean the engine bay, radiator and condenser, perfectly with nothing in the way. Replace all the ridiculous transmission mounts and brackets that are so difficult to reach in the car so easily when the K is on the ground. You can also roll it around anywhere on the two wheels I've been searching now for 20 minutes and I can't find a single RU-vidr doing it.

Why not drop the car on the discs and unbolt the side engine mounts and drop the engine to the floor the jack up the car? Seems easier than pulling the engine up.

How do you own a car lift but don't have a ball joint separator?

Song Is hella annoying but good info video

i'v remove the engine mount bracket with no impact gun,that was really really Hard 😵 daaaaaaamn

good video, question where did you bolt on the chain in order to pull out the engine?

Dude seriously, way to ruin a great video with horrible music, I can’t even hear you half the time.

When lifting the engine in the final step with the cherry picker, where do you attach the chain? I see the first spot on the transmission torque mount bolt but where does the other end attach to? I cant tell in the video.

He who's had engine lift but no ball joint fork has priorities fucked up.

Less of that corny music

Why not drop it out of the bottom?

Easiest way to remove…. Step one.. have lift. 😒

Is this an automatic transmission that you’re removing underneath or a manual transmission?

What's with the loud music blasts between your low tone voice?? Ouch Jeez!😮

very informative video

Wd40 from a can is best....

Your voice sounds like you would be a country music singer. Music sucks, but otherwise good video

Easy when you have a lift 😢

Gunjarte language. Ma vedio banvo ne

🫡