EASY ! FMS 800mm T-28 Trojan V2 | Reflex V2 stabilisation | Plug and Play | Ready to fly in 15 mins 

Thanks Mike 👍 Have an awesome weekend

With the V1 yes you can just fly it on 3s. These newer fms 800mm have higher KV motors and some like the F4u use 4 bladed props instead of 3 in V1 version, so these need to be taken into consideration. Best to use a watt meter first to measure amp draw at 50 percent throttle before going 3s on the newer versions.

@@robertwong2412 yep! I always check the amp draw to see if it will work!

True 🤣🤓😂

Good luck !

Even if the motor was 3S capable it would be a problem squeezing it into the slot far enough to get CG without cutting some foam.

@@EssentialRC Thanks for the info! It sounds like my P51D 750mm battery compartment. See you in the Air!

From memory yes and I had one spare

Tell me about it

Frsky receivers buddy. Wide choice. www.frsky-rc.com/product-category/receivers/2-4ghz-accst/

Reflex v2 limits roll to 30 to 40 degrees in Stabilised and prevents roll to inverted. Hope that helps.

@@EssentialRC Thanks! This is such a good feature!

No. When I use Stabilised (not a great name for that mode) it limits the bank and pitch rate and basically will not allow you to go inverted. If you use Optimised mode it reduces the affects of wind and has no limits on how you fly. If configured to change the mode via a 3 position switch you can also turn Reflex off.

Yes

Basically only use OFF or Optimised if its windy

❤

It could IF the plane was same type I think. Reflex can only be set to different pre-configured setups for FMS models via the provided USB lead and a desktop PC App. If you have another fixed wing warbird then I suspect the Reflex setup for the T-28 would work.

@@EssentialRC Thank you for your reply.

​@@EssentialRC I'm getting the fms corsair 800mm which comes with the same reflex V2 gyro as the T-28. I just wondered how do you setup the setting in the tx16s? Do u have to do your own mixing or setup in the transmitter?

@@TanLyeSiong Well, yes. You need to setup a model on your TX16S and bind to the receiver you are using in the model. Recommend you search on RU-vid for basic guide on how to setup a model with EdgeTX.

@@EssentialRC Thank you!

Well yes...doesn't seem to work though

@@EssentialRC bloody inter webs grrrr well if it’s any help I fall asleep to the channel on play all night 😂👍

I appreciate that some of my videos would easily send most viewers to sleep 🤣

@@EssentialRC your joking , favourite channel on here I feel I know that flying field like the back of my hand the amount of flights I watched , real pleasure watching you fly very inspirational, my other half….. not so much , I wonder how I’m gonna hide the new fox glider when it gets delivered (your guys fault yet again !😂)

Oh man...you will have so much fun with that !