Echo SRM-210 Carburetor Replacement 

Flip it to cold start and prime the bulb. Pull three times, move the choke to mid point, pull again. Save your pull cord!

Thanks for the detailed instructions. They were a big help to me.

Thank you so much!😊

I knew you would have a tough time replacing that grommet.. A huge tip.. stick an allen wrench down the line to make it stiffer and it goes into the grommet a lot easier.

I liked watching you have as many problems as I did, because as simple as this job is it's also a pain in the ass. When I cranked mine on the engine started but it was running at too many RPM's so now I have to figure out why. I changed mine in the florida heat, though it was dusk the humidity was draining my patience, on top of the mosquitos decided they wanted to eat me alive. After a lot of knuckle busting due to the conditions and a lot of sweat I shelved it and will go back today to figure out why the air to fuel mixture is running so rich. Great video!

Thank you for taking the time on showing this video!

Thanks for the vid man. About to go replace mine now

Never struggled so hard in my life to put that rubber seal in the gas tank!😡

there is seldom a need to remove the black plastic cover as u will loose the steel roller that holds it up.without it the needle position changes and it drags on housing wearing rapidly and affects needle adjustment severely.

Great video - had all the same issues you did from the stopper to the backwards throttle cable screw - appreciate you!

my weed eater would not run at high throttle so I replace the carb now I can't get it to run with the choke off if I cut the choke off it will stop running any thoughts

You need to adjust your needle settings.

Primer bulb is new but wont fill with fuel.

This is painful to watch.

What year that weed came out

Hands in the way, or your not even in frame.

cannot really see what you are doing. slide this ...take out screws.

Bad audio couldn't hear your voice