Electrical Designing of High Rise Building G+10 | Electrical Design Course 

Thank you too!

You are welcome. Make sure you subscribe and share it with your friend's and colleagues. Thanks ❤️

Always welcome 🙂

Yeah much easier than engineering theories. But on Job it is a challenge to deal with complexity of projects. This was just a basic sample to make it easier for audience to understand.

Request you to make video as soon as possible.

Keep watching

Thanks Saleem 😊

You're welcome

Glad it was helpful!

Most welcome

Thanks 😊

Thanks for liking. Keep watching!

Thanks a lot

Soon

Thanks 😎📽

Thanks 😊

Thanks 😊

was it 80-90% or 60-90%? I may be wrong.

Welcome 🙂

Thanks. Will make it soon.

I think common load should be seperated and it should have Seperate SMDB

Hi Franchette 👋, Thanks for watching. Yes, the design is as per Australian standards.

Safety factor

Total of both.

@@ElectricalInfinity but at any instant, both will not work together, then why we consider both load ? Is it general rule to consider both ?

That's why we take 0.7 demand factor after calculating total load.

Thanks

Noted

Will try to make one

Usually a cable between transformer and supply connection facility is provided by supply authority and is sized depending on transformer secondary side ampere setting. Supply connection facility is used by supply authority to set the current to certain required amperes depending on supply application done by electrical consultant by calculating max demand. The cable from supply connection facility is sized depending on circuit breaker setting in supply connection facility. I hope this answers your question.

@@ElectricalInfinity appreciate your reply..

Always cable +breaker is sized as per continous current of the Transformer + consider the derating factors for grouping depth of laying and Thermal withstand capacity. and also the voltage drop . all calculated precisely.

Please give the answer ?

IS 13010

@@ElectricalInfinity thank you so much

@@ElectricalInfinity can't find it in there... Is it mentioned explicitly that for a 2bhk this much capacity energy meter and so on... I have calculated loads of all flats individually but even after taking into diversity factor the load is quite large...

@@ElectricalInfinity also if I could discuss it with you somwhere else..

It's a general thumb rule contractor follows for considering total load. Usually it's 0-10 amps, 10-20amps and 20-30 amps energy meter rating.

Calculate VD on actual current , Not on Derated Current. Derated Current is only for cable+Equipment selection.

Will do separate video for that

You can get Transformer standard sizes from supply authority and cb sizes from manufacturer manuals or datasheets.

Buy TNEB Hand book.

Well we need add total load of the shop and consider demand factor as 0.8 to 0.9 for commercial places.

All loads are distributed equally among each phase of 3 phase supply. Usually the loads are single phase for example lighting circuits and power loads. If it's 3 phase load then a 3 Phase supply is provided.

@@ElectricalInfinity sir, then there are SPN inside the room which are not showing here???

upto 3KW - 1PH /240V IS enough , >3kw opt for 3ph 415v.

Logitech

Will make another video for that. The video would have become lengthier if added everything you asked for.

@@ElectricalInfinity Thank you

Steps 4 and 5 are different. This one is for high rise building not g plus 5. Watch it full you will know the difference. 😊

Thanks and sorry for that. You can use reduce the speed to 0.8x while watching