Elegoo Phecda Laser Limit switch by GeeksAtLarge installation 

Thanks for the review, especially the honesty that it wasn't perfect for you. I use this to improve the product. Side notes: 1. The X cable wire length between the controller and first limit is setup so that it matches up with the module cable and enters the gantry through the same notch. I'll update the instructions to make that a bit more clear. 2. The number of included cable clips is so that some can be used along the inside of the gantry. Your use zip ties also works too of course. 3. Next product update will have sleeved cables and have epoxy to keep the wiring intact at each connector. 4. For those that need them, longer screws for the right X limit (the one at the flame sensor) are also included. A small number of folks received machines with screws which were shorter than the machines I received, so longer versions were added to the kit just in case Thanks again!