Hi Kevin, Thank you for your videos.. for the 4 point marker.. does it only be set for the 1550 or both 1310 and 1550. My range is usually no longer than 1000ft. Thanks
Yes when measuring in real time you can only send one wavelength. Start with 1550 if it passes than 1310 should be fine. It will have higher loss but that is expected. If 1550 looks bad than check 1310 if 1310 is better you have a fiber management issue. You can toggle back and forth between 1410 and 1550 but keep in mind 1310 may require a longer pulse width to accommodate extra loss.
Hello, thanks for the video, I have just 1 question. Could you please explain why is the 4-Point event loss BEFORE cleaning lower than AFTER cleaning? With clean connector, I would expect lower loss and also lower reflectance...
Great question and a super simple answer. I did not take enough care to clean the connection. I used a one click and I did not really take much care. Ideally I would take my time, inspect and clean but for this training it was not important enough to add extra time to the video which resulted in not the most ideal cleaning.
It would be great if you can select to have only a 2 point loss. You basically can have that, but the text you read for capital A and capital B is very small unlike the large bold 4 point text. Any time I have every suggested useful thinsg for technicians, you don't listen.
If you are talking about Reflection from a connector typically see -45 to -50dB as acceptable Pass-Fail values. UPC connectors are -50 to -55dB at spec and APC -65dB or better. We start to see issues if we are worse than -40dB and if there is amplification of the signal it can be compounded.
Great question my friend. I cover this in another video ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-H_HBwFs8bd8.html this is called a gainer and is often from a Mode Field Diameter miss-match
Bonjour monsieur PERES, Je vous remercie de vos explications concernant l'OTDR.si vous pouvez me mettre quelques explications en français.encore merci beaucoup👍👍👍
Je parle une deuxième langue mais ce n'est pas le français. Je travaille pour une entreprise canadienne-française. Faites-moi savoir si vous avez besoin d'un enseignement en français et nous vous accommoderons sûrement!
Bonjour monsieur PERES, J'aime regardé votre vidéo qui explique les affaiblissements des événements sur 4 point marker otdr et la vidéo expliquant le lissage entre impulsion et temps. Si je peux avoir une traduction des deux vidéo en français,je serais le technicien le plus heureux grâce à vous. Merci beaucoup et continuer ainsi
@@Gigigigi-qx3vg J'aurais aimé parler français, mon entreprise est du Québec au Canada et ils parlent français, mais pas moi. Je parle encore 2 langues mais malheureusement le français n'est pas la seconde.
@@KevinPeres ,c'est avec grand plaisir que,j'ai lu votre message.Celà me fait énormément plaisir,je vous comprends, je serai aussi preneur en sous titrage en français. Continuer comme ça et grand merci à vous et votre équipe.vive la fibre cordialement Gigi
I will take a look at the video again. Setup is a big part of understanding optimizing 4 point measurement in real time. May be I can streamline that section a little more. I catered it to techs like myself at the time who worked in very restricted circumstances that required quick analysis.