Тёмный

Exterior Trim - Garage Door 

Horst Carpentry
Подписаться 13 тыс.
Просмотров 45 тыс.
50% 1

In this clip I remove and replace the jambs, brick molding ( casing ) and vinyl door sweeps on two garage doors. I use pre-primed 1 x 6 for the jamb work and pre-primed brick molding for the casing. Of course all cuts are back primed for longevity. I fill and caulk all the trim and then apply two coats of paint. I finish the job off by installing the vinyl door sweeps and checking the operation of the doors.
Tools used in this clip:
DeWalt 12" Chop Saw - amzn.to/2zXu777
Milwaukee 12V Circular Saw - amzn.to/2YRD63C
Milwaukee 12V Jigsaw - amzn.to/3dVa6ML
Milwaukee 12V Oscillating Saw / Multi Tool - amzn.to/3dTDwuG
DeWalt Air Compressor - amzn.to/3c3czoe
Air Hose - amzn.to/2Wo8x2R
Porter Cable 15GA Nailer - amzn.to/2LP1bR4
As an Amazon Associate I earn from qualifying purchases. Amazon links help support this these videos.
Thank you for watching and hope you enjoy the job

Хобби

Опубликовано:

 

1 июл 2020

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 57   
@julietphillips1991
@julietphillips1991 4 года назад
You didn't miss a single step! Big thumbs up!
@horstcarpentry
@horstcarpentry 4 года назад
Thank you and thanks for commenting
@terminalvelocity6398
@terminalvelocity6398 4 года назад
Great timing with this video. I need to do the same job on my garage doors. Now I know exactly what I'll be getting myself into.
@horstcarpentry
@horstcarpentry 4 года назад
Hope this was helpful for you. Thank you for watching and sharing your comments
@Eatables
@Eatables 4 года назад
I was watching rerun of your house addition series yesterday since I haven't seen you're posting lately :-) Good to see your videos again. You made it looks easy.
@horstcarpentry
@horstcarpentry 4 года назад
Thanks for watching and for the compliment. I'll try to not take so long to post my next video.
@dagored100
@dagored100 4 года назад
Thats very nice work..i love how you work...clean no mess around you
@horstcarpentry
@horstcarpentry 4 года назад
Thank you and glad you enjoyed watching the job.
@larrymcswain6785
@larrymcswain6785 4 года назад
Good to see you I was wondering where you were great videos
@horstcarpentry
@horstcarpentry 4 года назад
I've fallen behind a bit with my editing, but, I'm gonna try to not let that happen again. Thanks for following along
@peterkiernan1668
@peterkiernan1668 4 года назад
Nice neat and clean job, looks good.
@horstcarpentry
@horstcarpentry 4 года назад
Thank you and thanks for watching
@SnowDog080
@SnowDog080 4 года назад
Always a nice job!
@horstcarpentry
@horstcarpentry 4 года назад
Thank you and glad you enjoyed the job
@JoeGinty
@JoeGinty 2 месяца назад
Nice !
@suchoi61
@suchoi61 3 года назад
Pleace make new videos ! I can't wait ! All the best from switzerland Daniel
@horstcarpentry
@horstcarpentry 3 года назад
Thanks I will be back soon. I'm sorry for the delays. I have been working every single day since May and cannot get caught up. Soon I will get back to editing and posting videos again. Thanks for watching
@jeremyhuggins8796
@jeremyhuggins8796 4 года назад
You have a good hand for painting. Looks nice.
@horstcarpentry
@horstcarpentry 4 года назад
Thanks and glad you enjoyed watching
@jeremyhuggins8796
@jeremyhuggins8796 3 года назад
@@horstcarpentry Are you still making videos?
@horstcarpentry
@horstcarpentry 3 года назад
For right now....no, but, I plan to get back into he groove. I have been so slammed lately and working every single day to keep up with demand. Sorry for falling off the wagon. Hopefully it won't be much longer.
@spankiedoodlesteve2086
@spankiedoodlesteve2086 3 года назад
Need to get you some good rock n roll jammin in your new vids. Some of that Def Leppard or Boston or Kansas or something haha. I watch a ton of your vids lately and I got the same little electronic song stuck in my head and it’s been killin me. Bee bee bee boo bee bo beeeee. beeee bo beee be booooo! Hahaha
@horstcarpentry
@horstcarpentry 3 года назад
I wish I could but they would copyright strike my channel if I played it during the clip. You have to have the rights to any music to play it during the clips. Its kind of a bummer because it means no music while I work. Thanks for watching
@babyloveturd1218
@babyloveturd1218 3 года назад
Great video - and great timing... :) Question: What type of paint did you use? I need to fix mine up, but I'm not sure what kind of paint (besides exterior) to use. Thank you!
@horstcarpentry
@horstcarpentry 3 года назад
This homeowner had Behr paint, so, I used that brand for this project. I normally would use Sherwin Williams brand paint. It is more expensive, but, I prefer working with it. I'm glad you enjoyed the project and thanks for watching
@robertosi6521
@robertosi6521 4 года назад
Hello, Was wounder if you can give me some instruction how to do my self a extension patio from my roof. Thanks
@horstcarpentry
@horstcarpentry 4 года назад
I'm sorry, but, I am not able to give you the help that will need for that project.
@kalua241
@kalua241 3 года назад
Nice work! What did you do about the pierced J channels?
@horstcarpentry
@horstcarpentry 3 года назад
I informed the homeowner, and, came back afterwards and applied silicone to the holes. Hopefully that works out. Thanks for watching
@jacobworkman2177
@jacobworkman2177 2 года назад
Starting at 2:19 (and ending before nailing into the shims) what are you nailing into. Also how did you know how low to hang the horizontal 1x6? Thanks!
@horstcarpentry
@horstcarpentry 2 года назад
I was toe nailing into the stud just to hold it temporarily. At 2:27 I gauged the height of the 1 x 6 using a scrap of the brick molding to ensure it will fit. Thanks for the comment
@RyanJensenEE
@RyanJensenEE 2 года назад
You pointed out that the previous carpenter nailed right through the J-channel, but you didn't bother to replace it. That J-channel now has all these open holes (you removed the nails). Water will pool in the bottom of the J-channel and leak directly onto all the new wood you installed. I bet the paint will begin to discolor in a few years, and the wood will start rotting within 5-10 years because of all the moisture that is certain to build up underneath the hole-ridden J-channel. However, all is not lost. If you get back to this garage, replacing the J-channel around the garage door shouldn't be too much work. With new J-channel, the wood should be good for many decades to come.
@horstcarpentry
@horstcarpentry 2 года назад
You are correct, but, since this siding uses aluminum j channel it will be a hairy installation process. The issue has been addressed. Keep me honest....I appreciate the comment
@MrBaiJiu
@MrBaiJiu 3 года назад
So nice and clean looking, but that drip edge up top....
@horstcarpentry
@horstcarpentry 3 года назад
Thank you and.....I hear ya. I know that needs to be addressed. Thanks for watching
@terrell07981
@terrell07981 11 месяцев назад
How long did these two doors take?
@horstcarpentry
@horstcarpentry 11 месяцев назад
I completed the entire job in just a couple of days. I wanna say three days, but, I tend to work shorter days. Thanks for watching
@JuanMartinez-lp1bd
@JuanMartinez-lp1bd 3 года назад
What type of camera do you use?
@horstcarpentry
@horstcarpentry 3 года назад
I use a Moto E5 Play cell phone.
@susie11
@susie11 2 года назад
I just need the top jab and trim replaced, the person who supposedly fixed it just caulked patched it. Do you know cost and who to call to fix/ replace it?
@horstcarpentry
@horstcarpentry 2 года назад
If it is trimmed with wood then the jamb and trim probably cost around $50. The labor will vary a lot depending on where you live. I would charge $750 all in for labor and materials including painting. You should look for a handyman or carpentry company to help you with this repair. Thanks for watching
@susie11
@susie11 2 года назад
@@horstcarpentry thank you,yes just need the top part as my ex backed a truck into it then had it caulked. Paid to have it replaced and I think they just putty it. Wonder if I could pull it off and do it myself?
@horstcarpentry
@horstcarpentry 2 года назад
If they nailed the vertical boards together with the upper jamb then removing it will be a pain. They may have just installed the jamb top first then sides, but, this also will make it harder to remove the top without disturbing the sides. I'm sure that's why whomever came to "fix" it before cheated and ran. If you have the tools and a willingness to try then I'm sure you could do it. Just watch RU-vid videos to learn how to do it....🙂
@susie11
@susie11 2 года назад
@@horstcarpentry they definitely did cheat. Doesn't look replaced just filled and caulked. the filler washed away,rains a lot here. Hard being a girl for stuff like this. Charged me a ton.
@horstcarpentry
@horstcarpentry 2 года назад
Guys like that make me look great. I had a customer once that was stunned when I just showed up when I said I would. It's amazing how bad some solo guys are, but, some companies are just as bad. It's really hard to say there's a way to avoid it happening. I can only say that you should make sure the company is licensed and bonded to start. Then get multiple quotes and tell them that you are doing so. If anyone balks at that then dump them because it's a sign. After that I would ask for references and call them to verify. You won't get the cheapest guy in in town by doin this, but, sometimes you've just gotta pay for quality. I use subcontractors that are cash only, but, I've worked with them for years and know what I'm getting. I hope this helps you. Girls can do anything a guy can do. Biggest tool to fight that is knowledge so you can know when someone is taking advantage of you.
@delcohalf8754
@delcohalf8754 3 года назад
We miss u what going on its being a long time
@horstcarpentry
@horstcarpentry 3 года назад
I really appreciate everyone's support. I've been working every day since May. I'm planning to return to youtube. It is hard though because filming and editing takes a lot of time. I plan to make some changes next year to allow myself more time. Hopefully this will give me the time that I need to maintain my channel. Thanks again for sticking with me
@pollyg4160
@pollyg4160 3 года назад
will you come over and do our door? Thanks.
@horstcarpentry
@horstcarpentry 3 года назад
Sorry, but, I'm not taking any new jobs right now. Between making RU-vid clips and some personal projects I just don't have enough time to take on the work. Thank you for the offer though... I really appreciate it.
@delcohalf8754
@delcohalf8754 3 года назад
Qhat is goong.on we miss u much
@horstcarpentry
@horstcarpentry 3 года назад
Thank you, but, I've just been working 7 days a week and have not had any spare time to sit down and edit.
@kyleclem0520
@kyleclem0520 3 года назад
I like it, untill you started painting without a drop cloth. Good work tho
@horstcarpentry
@horstcarpentry 3 года назад
Thanks....I try my best to not drop and like everyone else think it'll never happen. But, you're right eventually I'll get burned. I will do better in the future. Thanks for watching
@jeremyhuggins8796
@jeremyhuggins8796 3 года назад
For unto us a child is born, unto us a son is given: and the government shall be upon his shoulder: and his name shall be called Wonderful, Counsellor, The mighty God, The everlasting Father, The Prince of Peace. Isaiah 9:6 MERRY CHRISTMAS! 🎄
@horstcarpentry
@horstcarpentry 3 года назад
Merry Christmas to you and your family this year. Thank you for this comment.
@jeremyhuggins8796
@jeremyhuggins8796 3 года назад
@@horstcarpentry 😊
Далее
Garage Build: Capping Door Frames With Aluminum
15:14
How To Install Door Trim: Beginner to Level 10 Pro!
15:14
How to Replace Garage Door Weather Stripping
6:11
Просмотров 260 тыс.
How To Upgrade Your Garage Door Trim
18:17
Просмотров 73 тыс.
Exterior Trim - Skill Level (Hard)
22:05
Просмотров 20 тыс.
Installing a 3 piece garage door strut kit
6:45
Просмотров 9 тыс.
Repair Rotted Garage Door Jamb!
8:27
Просмотров 220 тыс.
Сыграл на опережение #юмор
0:20
Сыграл на опережение #юмор
0:20