Hi! I was hoping to find an info on the marking on the flyweel (TDC market) and the position of piston as you shown with the tape. What should it be in fact? Is the TDC mark on the flywheel corresponding to 1st cylinder compression stage? Thanks for the vid.
my cj3a flywheel was installed out of sync. the tc and ign marks are 180 degrees off.. so I just find #1 tdc on compression stroke, after intake closed, and piston is at tdc... I detect that with a wire put in the plug hole, then use whatever distr. terminal the rotor is pointing at. good luck
Hello . Jst wanna ask about how to get the correct timeing on a willy cj3b jeep. Coz ive tried timeing it but itz loseing power coz just wanna ask u why is that hapenning.
Could be a number of things. Order the service manual and start with 1. battery/ignition cables, 2. spark plugs, 3. compression, 4. valve clearance, 5. distributor (check components/clean points, new condensor and points), 6. ignition timing (find TDC/ 5°BDC, retard or advance ignition), 7. carburetor (take off and service if not done already). Its best to get a service manual (can download online for free) and make it your bible. Good luck. Toiling with mine too.. :)
mannnn there is no apostrophe in WILLYS... so its WILLIS... a willie is what you pee with or is a country singer.... the jeep is a wILLIS... not a willies whew, now i feel better, so go ahead.
