hey, first thanks for the video. I have the same issue on my prusa mini and I hope I can solve it with this mod. but I don't understand one thing. in 5:22 the results before and after are just better in one point or am I wrong? the only one value that got better is the one from +0.23 to 0.1.. every other one is a little bit off compared to the one "before". why is that so? was it just this one point that was the problem?
I have a similar problem where the right side of my mini seems lower (prints lift off on right side but left side is fine). Couple of questions 1. I've done xz squaring and it looks to be almost perfect 2. Doesn't auto bed levelling correct this? No matter what I do, my right side seems to lack adhesion!
Bed levelling can only compensate so far - you need to perform the bed levelling mod - possibly as I did using shims to pack out the head bed. You can also adjust the first few layer print to 40% of normal print speed which should also help.
